Systems can pocket to left or right, and can stack to left and/or right. 45 and 90 degree configurations are available, as well as panoramic with a radius of minimum 72″....
Search Results "Minimum Dimension"
Filters
Commonly Searched Documents
-
Panda S.90 All Aluminum Slim Profile Multi-Slide Door System
-
Panda TS.83 Thermally Broken Multi-Slide Door System
Glazing: Clear Low-E tempered 1 3/8″ insulated glass is the standard, although a minimum of 1/4″ single pane glass to a maximum 1 1/2″ hurricane rated insulated glass may be used....
-
This is a great unit but it's not "recessed", it's semi-recessed.
If you place this unit next to the accessible lavatory or other required clear space and don't allow room for the projection, it may interfere with the minimum required clear floor space...
-
Assessment factors. (Section-by-Section Analysis)
The NPRM proposed the following specific assessment factors: (1) The dimensions, weight, and operating speed of the mobility device in relation to a wheelchair; (2) the potential risk of...
-
3.3 Guidance on the Visual Properties of Detectable Warnings
A detectable warning that provides a minimum luminance contrast of 60 percent could be seen from a distance of 2.44 m (8 ft) by approximately 92 percent of the pedestrians with visual impairments...
-
Acceleration
The AASHTO Guide for the Development of Bicycle Facilities (p. 65) uses a bicycle acceleration rate of 0.5 to 1 m/sec2 (1.5 to 3.0 ft/sec2) in its equation to determine the minimum green...
-
Sweep Width
The AASHTO Guide for the Development of Bicycle Facilities (pg. 22) recommends a minimum width for bike lanes as 1.2 m (4 ft).(2) Additionally it recommends (pp. 35-36) a minimum width of...
-
Section 36.406 Standards for New Construction and Alterations (Section-By-Section Analysis and Response to Comments)
which require the Attorney General to promulgate standards for accessible design for buildings and facilities subject to the Act and this part that are consistent with the supplemental minimum...
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, operable parts of controls and faucets shall be installed on the side wall of the compartment adjacent to the seat wall 19 inches (483 mm) minimum...
-
Communication Features in Guest Rooms
The Board had proposed increasing the minimum number of such guest rooms to 50% of the total number of guest rooms provided....
-
5.9.1 Standing Supports Recommendation In Reference To Mammography Equipment
To be useful, positioning supports must be shaped for grasping, positioned within reach range of all users, and be 12 inches long minimum when located on the moving c-arm or 18 inches long...
-
Standing Supports [M305.2]
To be useful, positioning supports must shaped for grasping, positioned within the reach range of all users, and be 12 inches long minimum when located on the moving c-arm or 18 inches long...
-
Protocol A Heights Obtained
20 14 10 10 Table E4 Alternative Text Description: This table shows the attainable height percentiles for Protocol A minimum...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
Conclusion
Where the playground surface fails to comply with the minimum accessibility standards, children with mobility impairments may be regulated to the sidelines only to look on. ...
-
Accessible Routes - Interior and Exterior
Requirements: At least one route that is a minimum of 36 inches wide without steps, stairs, or other abrupt level changes must be provided within the boundary of the lodging facility's...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, operable parts of controls and faucets shall be installed on the side wall of the compartment adjacent to the seat wall 19 inches (483 mm) minimum...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
1134A.5, Item 1
There shall be a minimum clear floor space 48 inches parallel by 30 inches perpendicular (1219 mm by 762 mm) to the side of a bathtub or bathtub-shower combination to provide for the maneuvering...
-
F213.3.1 Toilet Compartments
Full-height partitions and door assemblies can comprise toilet compartments where the minimum required spaces are provided within the compartment....
-
1016.4 Passing Spaces
Entities should consider providing either a 60 inches (1525 mm) minimum clear width on outdoor recreation access routes or passing spaces at shorter intervals if the clear width is less...
