(e) For vehicles in excess of 22 feet in length with front-door lifts or ramps, vertical stanchions immediately behind the driver shall either terminate at the lower edge of the aisle-facing...
Search Results "Door Opening Angle"
Filters
Commonly Searched Documents
-
§ 38.29(e)
-
11B-213.2.1 Unisex (single-user or family) toilet and unisex (single-user or family) bathing rooms
Doors to unisex (single-user or family) toilet rooms and unisex bathing rooms shall have privacy latches....
-
Captioning at movie theaters. (Section-by-Section Analysis)
Both open and closed captioning are examples of auxiliary aids and services under the Department's regulation. 28 CFR 36.303(b)(1). ...
-
Welcome and Charge to Participants
And the standard, despite all the iterations of the standard over time, has never made any allowance for [the] opening force for doors, other than the width of the door and some threshold...
-
Hadrian Inc. Specialty Lockers
Additionally, Hadrian’s standard friction catch and positive latch options allow doors to be operated with one hand and without the need for grasping, pinching or twisting of the wrist....
-
Interacting with People with Visual Disabilities
When guiding a person through a doorway, let them know if the door opens in or out and to the right or to the left. Before going up or down steps, come to a complete stop....
-
11B-608.2.2 Standard roll-in type shower compartments
roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides with a full opening...
-
1007.2 Continuity and components
Where the exit stairway is open to the exterior, the accessible means of egress shall include either an area of refuge in accordance with Section 1007.6 or an exterior area for assisted...
-
ADA Quick Tips - Sign Language Interpreters
TITLE III of the Americans with Disabilities Act (ADA) makes it illegal for any business, building or other place that is open to the public to discriminate against people with disabilities...
-
§27.127(e)(2)
All documents and other evidence offered or taken for the record are open to examination by the parties and opportunity is given to refute facts and arguments advanced by either side....
-
1018.4 Clear Width
Gates or barriers that have clear openings at least 48 inches wide will accommodate most beach wheelchairs....
-
Are detectable warnings required on curb ramps or at hazardous vehicular areas?
Under the ADA Standards, which apply primarily to facilities located on sites, detectable warnings are required at transit facilities (at curb ramps and along open drop-offs of rail station...
-
11B-608.2.2 Standard roll-in type shower compartments
roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides with a full opening...
-
Expert Report of John Rife Torkelson, theACCESSpartnership, L.P. (August 8, 2018)
Building Entrance: One side of the double leaf doors at the designated accessible entrance does not provide at least 32 inches clear passage width when the door is open 90 degrees (1991...
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Anatomical Area) Associated Anthropometric Dimensions 1 Vertex of Head Height: Sitting Height, Vertical Head Clearance Breadth/Width: Head Lateral Location Angles...
-
Appendix D: Photometric Measurements
All measurements were made at an angle of 45 degrees relative to the horizontal test surface looking in the same direction that the participants viewed the detectable warnings during their...
-
Pilot Rock XT and XTH Series End Accessible Picnic Table Using Aluminum
Top/seat mounting angles are 2" x 2" x 3/16" steel angles. Frames supported by diagonal braces of 1-5/16" OD steel pipe attached to steel center channel. ...
-
Pilot Rock WXT and WXTH Picnic Table Using Lumber
Top/seat mounting angles are 2” x 2” x 3/16” steel angles. Frames supported by diagonal braces of 1-5/16” OD steel pipe attached to center channel. ...
-
Pilot Rock WUT and WUTH Picnic Table Using Recycled Plastic
Top/seat mounting angles are 2” x 2” x 3/16” steel angles. Frames supported by diagonal braces of 1-5/16” OD steel pipe attached to center channel. ...
-
Pilot Rock WUT and WUTH Picnic Table Using Formed Steel Channel
Top/seat mounting angles are 2” x 2” x 3/16” steel angles. Frames supported by diagonal braces of 1-5/16” OD steel pipe attached to center channel. ...
-
Pilot Rock UT and UTH Series End Accessible Picnic Table Using Lumber
Top/seat mounting angles are 2" x 2" x 3/16" steel angles. Frames supported by diagonal braces of 1-5/16" OD steel pipe attached to steel center channel. ...
-
Pilot Rock WXT and WXTH Picnic Table Using Recycled Plastic
Top/seat mounting angles are 2” x 2” x 3/16” steel angles. Frames supported by diagonal braces of 1-5/16” OD steel pipe attached to center channel. ...
-
Pilot Rock UT and UTH Series End Accessible Aluminum Picnic Table
Top/seat mounting angles are 2" x 2" x 3/16" steel angles. Frames supported by diagonal braces of 1-5/16" OD steel pipe attached to steel center channel. ...
