Photometry is the measurement and specification of light (visible radiant energy) based on the standardized spectral sensitivity of the human visual system....
Search Results "Hybrid Surface System"
Filters
Commonly Searched Documents
-
Appendix D: Photometric Measurements
-
Can van spaces required for a parking garage be located in a surface lot instead?
No. Accessible parking, including van spaces, required for one parking facility can be located in another parking facility only where it results in substantially equal or greater...
-
11B-803.6 Mirrors
Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground....
-
Direct Connections: ADA Standard Section 206.4.4.2
Section 206.4.4.2 covers scoping requirements in the most current ADA Standards for accessible routes to direct connections at transportation facilities.
-
Sloped Entries
Sloped Entries Sloped entries must comply with ADAAG accessible route provisions (36 inch minimum width, maximum 1:12 or 8.33% slope), except that the surface does not need to be slip...
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
The need to reach heights above 32 inches interferes with efforts to lower the transfer surface height....
-
Seton EZ-Roll Sign Stanchion Systems - Parking Sign PP244
Grab the nylon loop handle and roll sign smoothly along on the wheels at the base Fill the 24" base with sand or water to withstand wind gusts of up to 40...
-
Safe-T Systems Fire Guard Portable Fire Extinguisher Stands
Fire Guard portable fire extinguisher stands, are an ideal solution to the common problem of locating fire extinguishers on job sites, project areas, and remote working...
-
4. Perspectives of Equipment Types
NM/CT Combined Systems PET/MR Combined System These represent all virtually all diagnostic imaging systems except conventional Mammographic systems which were addressed...
-
11B-201.3 Temporary and permanent structures
buildings or facilities covered by these requirements include, but are not limited to, reviewing stands, temporary classrooms, bleacher areas, stages, platforms and daises, fixed furniture systems...
-
11B-206.4.4.2 Direct connections
Direct connections to other facilities shall provide an accessible route complying with Section 11B-404 from the point of connection to boarding platforms and all transportation system elements...
-
NAADAC Webinar Series: "ADA: The Next Generation" - Virtual and At-Home Training
This unique and important series of seven webinars brings together some of the country’s most experienced ADA experts and trainers, combining the “official” view with practical...
-
Attachment A: Violations Identified in the United States' Letter of Findings (Sept. 29, 2014)
[See subsections ...]
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
Emergency Communications: ADA Standard Section 409.4.7
Section 409.4.7: covers the current ADA Standards for the elevator emergency communication systems in private residence elevators.
-
11B-705.3 Product Approval
Only approved DSA-AC detectable warning products and directional surfaces shall be installed as provided in the California Code of Regulations (CCR), Title 24, Part 1, Chapter 5, Articles...
-
References
Standard specification for impact attenuation of surface systems under and around playground equipment. ASTM F1292‒99/04, 15.07. ...
-
Handi-Ramp Galvanized Steel Ramps
Each section can be used individually or as a component of a larger wheelchair ramp system....
-
11B-809.9.2 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, work surface or the face of any appliance (excluding handles and controls) and the opposing cabinet, work surface,...
-
11B-411.2.1.7.3 Assignment by security credential
If a security system or other form of access control system is provided, the audio output shall provide a verbal announcement and direction to the location of the access control activation...
-
American Specialties Stainless Steel Surface Mounted Paper Cup Dispenser 0002-SM
Dispenses 100 flat bottom cups. Adjustable for 3 oz. thru 6 oz. cups. Stainless steel with bright finish.
-
American Specialties Turbo-Dri Jr. Surface Mounted High-Speed Dryer 0198
Compact high-speed hand dryer for applications where less space is available. 5-year warranty. FEATURES: Quick drying — less than 15 seconds Operates automatically using...
-
AJW Architectural Products U156 32 oz. Vertical Soap Dispenser - Surface Mounted
Product Features Globe is translucent, shatterproof and corrosion resistant molded polyethylene Fabricated of highly polished chrome plated ABS material Holds 32 oz. of...
-
American Specialties Surface Mounted Twin Hide-A-Roll Toilet Tissue Dispenser 0030
Holds two rolls up to 5 1/4" (135 mm) diameter (1800 sheets). Top roll automatically drops in place when bottom roll is used up. Type 304 stainless steel cabinet and mechanism. Theft...
