Raised symbols or characters, white on a black background, and Braille shall be provided adjacent to the device and shall comply with Sections 11B-703.2 and 11B-703.3....
Search Results "MUTCD: Manual on Uniform Traffic Control Devices for Streets and Highways"
Commonly Searched Documents
-
11B-407.4.9 Emergency communication
-
11B-206.8 Security barriers
Exception: Where security barriers incorporate elements that cannot comply with these requirements such as certain metal detectors, fluoroscopes, or other similar devices, the accessible...
-
A4.28.4 Auxiliary Alarms
To be effective, such devices must be located and oriented so that they will spread signals and reflections throughout a space or raise the overall light level sharply....
-
Restricted Entrance
An entrance that is made available for common use on a controlled basis but not public use and that is not a service entrance....
-
RESTRICTED ENTRANCE
An entrance that is made available for common use on a controlled basis, but not public use, and that is not a service entrance....
-
Alterations [4.1.6(1)(f) & (k)]
For example, if the planned scope of work is limited to replacement of an elevator cab's control panel, then at a minimum the new control panel must comply to the maximum extent feasible...
-
II-3.6100 General.
ILLUSTRATION 4: C, a person with a disability, stops at a rest area on the highway....
-
406.4.1 Clear height
The clear height of each floor level in vehicle and pedestrian traffic areas shall be not less than 7 feet (2134 mm). Advisory 406.4.1 Clear height. ...
-
11B-409.4.7.3 Compartment
If the telephone or device is in a closed compartment, the compartment door hardware shall comply with Section 11B-309....
- Self Reliance, Inc. - Tampa, FL
-
For more specific information about ADA requirements affecting employment contact:
more specific information about requirements for accessible design in new construction and alterations contact: Architectural and Transportation Barriers Compliance Board 1111 18th Street...
-
A4.32.4 Height of Tables or Counters
Heavy manual work such as rolling dough requires a counter or table height about 10 in (255 mm) below elbow height for a standing person....
-
A4.32.4 HEIGHT OF WORK SURFACES
Heavy manual work such as rolling dough requires a work surface height about 10 in (255 mm) below elbow height for a standing person....
-
Check Braille
If possible, have a person who reads Braille confirm that the name on APS is the name of the street that the arrow points toward....
-
R207.2 Alterations
In alterations where existing physical constraints prevent compliance with R207.1, a single diagonal curb ramp shall be permitted to serve both pedestrian street crossings....
-
Road Roughness Analysis
Serviceability is a criterion measure for highway surfaces based on surface roughness, which is then used as a determinant need for rehabilitation of highway surfaces....
-
CONCLUSIONS
• Sand (SAND) is the most difficult surface for all user groups, but the difference is particularly dramatic for those using a manual wheelchair....
-
Detectable Warnings [4.7.7]
required a distinctive dome patterning for the surface of curb ramps detectable by canes or by foot so that people with vision impairments could detect the transition from pedestrian area to street...
-
1010.2.2 Hardware
Door handles, pulls, latches, locks and other operating devices on doors required to be accessible by Chapter 11A or 11B shall not require tight grasping, tight pinching or twisting of the...
- ACCESSMAT® - EN - Beach accessibility mats
-
702.2 Advanced Television Systems Committee (ATSC)
Copies of the referenced standard may be obtained from the Advanced Television Systems Committee, 1776 K Street NW, Suite 200, Washington, DC 20006–2304 (http://www.atsc.org)....
-
DRIVEWAY
A vehicular way providing access between a public way and a building, parking facility, or other off-street area. A driveway may provide access to drive aisles in a parking facility....
-
11B-407.4.6.3 Keypads
Car control keypads shall be in a standard telephone keypad arrangement and shall comply with Section 11B-407.4.7.2....