The 1991 Standards at section 4.1.1(3), and the 2010 Standards at section 203.9, require employee work areas in new construction and alterations only to be designed and constructed so that...
Search Results "Franchise Design"
Filters
Commonly Searched Documents
-
Common Use Circulation Paths in Employee Work Areas
-
Meeting ANSI Standard S12.60 Requirements
Designing a classroom to meet the acoustical requirements of the ANSI standard is neither difficult nor costly....
-
c) Aquatic Program
The three pools Kirola complained about were not designated as accessible at the time of trial. However, program access does not require the City to make every pool accessible....
-
A MINIMUM HIGHEST POINT STANDARD OF 19 INCHES IS CONSISTENT WITH EXISTING ACCESSIBILITY STANDARDS
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area.16 As...
-
Section 36.406(d) Social Service Establishments (Section-by-Section Analysis)
The two design standards for accessibility (i.e., the 1991 Standards and UFAS) have confronted many social service providers with separate, sometimes conflicting requirements for the design...
-
Section 35.151(e) Social Service Establishments (Section-by-Section Analysis)
The two design standards for accessibility--i.e., the 1991 Standards and UFAS--have confronted many social service providers with separate, and sometimes conflicting, requirements for design...
-
Conferences Audio, Conferences, Webinars and Web Courses
This program is designed to enhance an individual's existing knowledge base or facilitate continued learning regarding regulations and trends under the ADA....
-
Other Power-driven Mobility Devices (OPDMDs)
type, size, weight, dimensions, and speed of the device; volume of pedestrian traffic (which may vary at different times of the day, week, month, or year); the facility's design...
-
Use of the International Symbol of Accessibility and Other Signs
In accordance with ABAAS, section 216, ISA must be posted at only six places: At accessible parking spaces in parking lots with five or more designated parking spaces....
-
Slopes and Resting Intervals for Outdoor Recreation Access Routes
Design Tip The cross slope requirement depends on what material is used. Those who use a mobility device know that as cross slope increases, travel becomes more difficult....
-
BACKGROUND
The Board then designates them as "accessible," which indicates compliance with State guidelines, or "not fully accessible."...
-
3. Statutory and Regulatory Background
Department of Defense, Department of Housing and Urban Development, General Services Administration, and United States Postal Service are required to adopt accessibility standards for the design...
-
Accessibility - Flatness and Lippage
Because the flatness of wood and concrete substrates can change over time, it is recommended that the designer make provisions for evaluating substrate flatness just before installation...
-
Standing Supports (M304.3 and M305.3)
Tilley, The Measure of Man & Woman: Human Factors in Design, (New York, John Wiley and Sons, 2002), page 43....
-
F105.2.2 ASME
ASME A17.1-2000 is used by local jurisdictions throughout the United States for the design, construction, installation, operation, inspection, testing, maintenance, alteration, and repair...
-
§ 382.61 Training
(7) Current employees of each carrier designated as complaints resolution officials, for purposes of § 382.65 of this part, shall receive training concerning the requirements of this...
-
Accessible Route
The list of exceptions specifies alternate design requirements applicable to these structures which, because of water level variables, cannot comply with the slope, cross slope, and handrail...
-
36 CFR Part 1190, Proposed Accessibility Guidelines for Pedestrian Facilities in the Public Right-of-Way; Shared Use Paths (SNPRM)
Shared use paths are multi-use paths designed primarily for use by bicyclists and pedestrians, including pedestrians with disabilities, for transportation and recreation purposes....
-
4.1.3 Adjustable Height Chairs with and without Footplates
a minimum 2” clearance is required from the floor to the bottom of the footplate as specified by domestic UL and International Electrotechnical Commission (IEC) standards (as currently designed...
-
A. Statutory and rulemaking history
The ADA also requires newly designed and constructed or altered State and local government facilities, public accommodations, and commercial facilities to be readily accessible to and usable...
-
Issue 15: How can the potential conflict between the goals of zero net energy and accessibility for low vision persons be resolved?
And I’ve already sent Eunice a contact for someone who certainly advocates with NFPA on stairway design issues, including lighting....
-
Safe harbor for qualified small businesses regarding what is readily achievable. (Section-by-Section Analysis)
Commenters were concerned that, absent a standard, unsafe or ineffective design practices might be undertaken. ...
-
A) Accessible Parking
Accessible Parking Spaces for Cars Accessible parking spaces for cars have at least a 60 inch-wide access aisle located adjacent to the designated parking space....
-
§35.130(d) and §35.130(e) (Section-by-Section Analysis)
Section 501(d) was designed to clarify that nothing in the ADA requires individuals with disabilities to accept special accommodations and services for individuals with disabilities that...