(2) If the six-foot clearance is not feasible (e.g., where such a clearance would create an insurmountable gap on a mini-high platform or where the physical structure of an existing station...
Search Results "Door Maneuvering Clearance"
-
§ 37.42(e)(2)
-
Kitchen Counters, Walls, and Floors
Staggered stud construction to prevent noise transmission to other rooms Zero clearance kitchen entries with less than 1/4” change of elevation throughout the accessible route. ...
-
§ 38.77(b)
Handrails shall be placed to provide a minimum 11/2 inches knuckle clearance from the nearest adjacent surface....
-
Operable Parts: ADA Standard Section 611.3
Section 611.3 covers the current ADA Standards for the operable parts of washing machines and clothes dryers.
-
11B-409.4.7.3 Compartment
If the telephone or device is in a closed compartment, the compartment door hardware shall comply with Section 11B-309....
-
11B-409.4.7.3 Compartment
If the telephone or device is in a closed compartment, the compartment door hardware shall comply with Section 11B-309....
-
18(b)
with ADA Standards § 9.3 will be achieved by providing visual alarms connected to the building emergency alarm system, and visual notification devices for incoming telephone calls and door...
-
18(a)
with ADA Standards § 9.3 will be achieved by providing visual alarms connected to the building emergency alarm system, and visual notification devices for incoming telephone calls and door...
-
Landings [4.8.4]
Landings at the top and bottom and intermediate landings, must be at least 60 inches long so maneuvering space is available for approaching ramps straight on....
-
Top Landing [§406.4]
Side flares, where provided, are intended primarily to prevent tripping hazards, not to accommodate wheelchair maneuvering at ramps (except in alterations where sufficient landing space...
-
Fixtures
Fixtures TAS 604.3.2 also allows the clear floor space and clearances required at other “fixtures” to overlap the water closet clearance....
-
§ 38.127(a)
(a) Sleeping compartments required to be accessible shall be designed so as to allow a person using a wheelchair or mobility aid to enter, maneuver within and approach and use each element...
-
11B-809.7 Accessible routes
The accessible route shall pass through the primary entry door, through all rooms within the dwelling unit and exterior decks and balconies....
-
11B-809.7 Accessible routes
The accessible route shall pass through the primary entry door, through all rooms within the dwelling unit and exterior decks and balconies....
-
11B-604 Water closets and toilet compartments
routes, clear floor space and clearances required at other fixtures, and the turning space....
-
11B-611.3 Operable parts
Operable parts, including doors, lint screens, and detergent and bleach compartments shall comply with Section 11B-309....
-
11B-611.3 Operable parts
Operable parts, including doors, lint screens, and detergent and bleach compartments shall comply with Section 11B-309....
-
1009.9 Signage
Signage indicating special accessibility provisions shall be provided as shown: Each door providing access to an area of refuge from an adjacent floor area shall be identified by a...
-
1009.9 Signage
Signage indicating special accessibility provisions shall be provided as shown: Each door providing access to an area of refuge from an adjacent floor area shall be identified by a...
-
306.3.5 Width
Knee clearance shall be 30 inches (760 mm) wide minimum. Figure 306.3 Knee Clearance...
-
608.1 General
Shower stalls that are 60 inches (1525 mm) wide and have no curb may increase the usability of a bathroom because the shower area provides additional maneuvering space....
-
608.1 General
Shower stalls that are 60 inches (1525 mm) wide and have no curb may increase the usability of a bathroom because the shower area provides additional maneuvering space....
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
ACCESS AISLE
[DSA-AC] An accessible space adjacent to or between vehicle spaces that provides clearances in compliance with this code....