SDC HiTower® locksets comply with all national and regional building codes for locking interior office, elevator lobby, exit and stairwell fire rated doors, where the use of electric strikes...
Search Results "Ground Floor Exit"
- SDC Z7500 HiTower Pro Series Actuator Controlled Locksets
-
Height: ADA Standard Section 1005.2.1
At least 25 percent of the railings, guards, or handrails shall be 34 inches (865 mm) maximum above the ground or deck surface....
-
11B-204.1 General
Within play areas, protruding objects on circulation paths shall not be required to comply with Section 11B-307 provided that ground level accessible routes provide vertical clearance in...
-
11B-204.1 General
Within play areas, protruding objects on circulation paths shall not be required to comply with Section 11B-307 provided that ground level accessible routes provide vertical clearance in...
- Collapsible Water Retainer Shower Dam for Shower Threshold Information Video
-
M305.3.1.2 Diagnostic Equipment Containing a Wheelchair Space
On diagnostic equipment containing wheelchair spaces with one entry that also serves as the exit, the length of the gripping surface of horizontal standing supports shall be equal to or...
-
Surprise Drills
., blocked paths or exits), forcing people to use alternative routes. Performance of these drills should also be evaluated and feedback given to all participants. ...
-
Door Closers [4.13.10]
it may be difficult for a person with a disability to open a door against the resistance offered by a closer, it is important that the closing action be slow enough to allow entry and exit...
-
Elevators with Standby Power [IBC §1007.4 (2003), §1003.2.13.3 (2000)]
In buildings with four or more stories above or below the level of exit discharge, at least one accessible means of egress must be an elevator with standby power and emergency signaling...
-
Emergency Planning
detail procedures for providing evacuation assistance to people who would have difficulty or who would be unable to: Use stairwells, Hear alarms, See exits...
- Wikk Industries Inc. PART# BPS IG HL/LO CLEAR (628)
-
11B-604.8.1.4 Toe clearance
At least one side partition shall provide a toe clearance of 9 inches (229 mm) minimum above the finish floor and 6 inches (152 mm) deep minimum beyond the compartment-side face of the partition...
-
11B-604.8.1.4 Toe clearance
At least one side partition shall provide a toe clearance of 9 inches (229 mm) minimum above the finish floor and 6 inches (152 mm) deep minimum beyond the compartment-side face of the partition...
-
Accessible Pathway & Corridor: Minimum Clear Floor Space Required for 360-degree Turn
This data depicts the amount of space required by users of wheeled mobility devices to perform a 360-degree turn. The bold dashed line in the table and figure indicates the...
-
11B-407.4.8.2.1 Signal type
The signal shall be an automatic verbal annunciator which announces the floor at which the car is about to stop....
-
11B-407.4.8.2.1 Signal type
The signal shall be an automatic verbal annunciator which announces the floor at which the car is about to stop....
- Spectrum Aquatics Gallatin Water Powered Assisted Access Lift
-
Contents:
breathing, allergies, hearing, seeing, walking, understanding or chronic conditions) may have difficulty or be unable to: use stairwells hear alarms see or read exit...
-
68.30(2) Places Used Primarily for Religious Rituals
This exemption does not apply to the following: parking facilities, accessible routes, walkways, hallways, toilet facilities, entrances, public telephones, drinking fountains, and exits;...
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area at the exterior side of the primary entry door and any required exit doors shall comply with Section 1126A....
- Wikk Industries Inc. Bollard With Push Plate PART# BPRT1435CSFT32D (630)
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
The symbol shall be mounted at 58 inches (1473 mm) minimum and 60 inches (1524 mm) maximum above the finish floor or ground surface measured from the centerline of the symbol....
-
11B-220.2 Point-of-sale devices
Where point-of-sale devices are provided at check stands and sales and service counters, they shall comply with Section 11B-707.9.1, and shall also comply with Sections 11B-707.2 _|Clear Floor...
-
4.2 Physical Accessibility Barriers and Solutions
and sign in Place sign check-in equipment on a side table or use a clipboard Install a lower countertop or lower a section of the existing counter Facility has two floors...