Each passenger elevator provided, whether required or not, must comply with the ADA Standards....
Search Results "Proposed Standard"
-
Required Compliance [§206.6]
-
New Construction and Alterations
These curb ramps must comply with the 2010 Standards.3 DOT’s Section 504 Federally assisted regulation also requires the provision of curb ramps in new construction and alterations. ...
-
Elevator Car Controls
Comments recommended that the height of elevator car controls be harmonized with the ANSI A117.1 standard....
-
Standby Power for Platform Lifts
The 2010 Standards at section 207.2 require standby power to be provided for platform lifts that are permitted to serve as part of an accessible means of egress by the IBC....
-
1117B.5.6
California's standards for signage are more stringent than Section 4.30 of the ADA Standards for Accessible Design. 1117B.5.6 Braille. ...
-
G) Parks and Recreation Programs
When the facilities are built or altered, they must comply with the ADA Standards, which have specific technical requirements for elements and spaces, such as accessible parking spaces,...
-
New Construction
The 2010 Standards set out the minimum accessibility requirements for newly constructed facilities. 2010 ADA Standards Basics Chapter 1: Application and Administration...
-
3.3.11 180-Degree Turn
The U.S. standard of 1525 mm (60 in.) accommodates just over 80% of the manual and powered wheelchair users, but less than 50% of the scooter users in our sample....
- California Building Officials (CALBO)
-
B.6.ii. - If an agency determines that the acquisition of EIT that meets the applicable technical provisions of the Access Board’s standards would impose an undue burden, does it have any remaining obligations under Section 508?
Yes. The statute requires that the information and data be provided to individuals with disabilities by an alternative means of access. For example, if an agency wishes to purchase a...
-
Elevator Landings
In the final rule, this provision has been editorially revised to refer to elevator "landings," consistent with the ANSI A117.1‒2003 standard....
-
Signs Required at Waiting Lines to Amusement Rides
Section 216.12 of the 2010 Standards requires signs at entries to queues and waiting lines identifying type and location of access for the amusement ride....
-
1008.2.6.2 Use Zones
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
Accessible Means of Entry to Wading Pools
Sections 242.3 and 1009.3 of the 2010 Standards require that at least one sloped means of entry is required into the deepest part of each wading pool....
-
1008.2.6.2 Use Zones
Ground surfaces located within use zones shall comply with ASTM F 1292 (1999 edition or 2004 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
d. ii.
See Standards §§ 4.2.5 and 4.2.6....
-
T403.1 General
Lifts shall comply with T403 and the National Highway Traffic Safety Administration’s Federal Motor Vehicle Safety Standards (FMVSS) for public use lifts at 49 CFR 571.403 and 571.404....
-
412.8.3 Signal Compatibility
ICT shall support all commonly used cross-manufacturer non-proprietary standard TTY signal protocols where the system interoperates with the Public Switched Telephone Network (PSTN)....
-
702.2 Advanced Television Systems Committee (ATSC)
Copies of the referenced standard may be obtained from the Advanced Television Systems Committee, 1776 K Street NW, Suite 200, Washington, DC 20006–2304 (http://www.atsc.org)....
-
H25
[ADA Standards § 4.13.5] Yes No...
-
H11
[ADA Standards § 4.19.6] Yes No...
-
H23
[ADA Standards § 4.17.3] Yes No...
-
J4
[ADA Standards §§ 4.15.3 and 4.15.4] Yes No...
-
C1-c
[ADA Standards § 4.3.3] Yes No If No, does the accessible route narrow to 32 inches for no more than 2 feet?...