EXCEPTION: Where compliance is not operationally or structurally feasible, ramps, bridge plates, or similar devices complying with the applicable requirements of 36 CFR 1192.83(c) shall...
Search Results "Structural Work"
Commonly Searched Documents
-
Gaps: ADA Standard Section 1002.4.3
-
4.1.6(3)(b)
(b) At least one accessible entrance complying with 4.14, Entrances. If additional entrances are altered then they shall comply with 4.1.6(a); and
-
§ 37.43(b)
(b) As used in this section, the phrase to the maximum extent feasible applies to the occasional case where the nature of an existing facility makes it impossible to comply fully...
-
A4.32.4 HEIGHT OF WORK SURFACES
Different types of work require different work surface heights for comfort and optimal performance....
-
203.1 General
EXCEPTION: In new construction, full compliance with the requirements of these standards is not required where an entity can demonstrate that it is structurally impracticable to meet the...
- Populas Accella Adjustable Activity / Computer Workstation
-
Alterations: ADA Standard Section 233.3.4
Section 233.3.4: covers scoping requirements in the current ADA Standards for alterations to residential facilities.
-
Employee Work Areas—Section 203.9 of the 2010 Standards, and Similar Sections
The 2010 Standards require a more limited level of access within employee work areas in ADA-covered facilities than UFAS, which requires employee work areas to be fully accessible....
-
Technically Infeasible
With respect to an alteration of a building or a facility, something that has little likelihood of being accomplished because existing structural conditions would require removing or altering...
-
Technically Infeasible
With respect to an alteration of a building or a facility, something that has little likelihood of being accomplished because existing structural conditions would require removing or altering...
- Populas Infinity Workstation
-
TECHNICALLY INFEASIBLE
An alteration of a building or a facility that has little likelihood of being accomplished because the existing structural conditions require the removal or alteration of a load-bearing...
-
4.17.3 SIZE AND ARRANGEMENT
Figure 30 Toilet Stalls EXCEPTION: In instances of alteration work where provision of a standard stall (Fig. 30(a)) is structurally impracticable or where plumbing...
-
106.5.68 Technically Infeasible
With respect to an alteration of a building or a facility, something that has little likelihood of being accomplished because existing structural conditions would require removing or altering...
-
Dumpster Enclosures
Dumpster Enclosures Dumpster enclosures used exclusively by employees shall be considered employee work areas based on TAS 201.1; therefore, they must comply with TAS 203.9....
-
11B-809.9.3 Removable base cabinets
Knee and toe space complying with Section 11B-306 shall be provided at sinks and work surfaces required to comply with Section 11B-809.9.4....
- Smith System Husky Rectangle Activity Table 24″ Deep
- Teknion Journal Extended Range Height-Adjustable Table
-
1133A.4, Item 2
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for a work surface....
-
1133A.4, Item 2
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for a work surface....
-
1.9.1.2.4
1.9.1.2.4 All existing privately funded public accommodations when alterations, structural repairs or additions are made to such public accommodations as set forth under Chapter 11B....
-
1.9.1.2.4
1.9.1.2.4 All existing privately funded public accommodations when alterations, structural repairs or additions are made to such public accommodations as set forth under Chapter 11B....
-
Clear Floor or Ground Space: ADA Standard Section 804.3.1
The clear floor or ground space shall be centered on the kitchen work surface and shall provide knee and toe clearance complying with 306....
-
11B-804.3.1 Clear floor or ground space
The clear floor or ground space shall be centered on the kitchen work surface and shall provide knee and toe clearance complying with Section 11B-306....