Diagonal or corner type curb ramps with returned curbs or other well-defined edges shall have the edges parallel to the direction of pedestrian flow....
Search Results "Shower Curb"
Commonly Searched Documents
-
11B-406.5.10 Diagonal curb ramps
-
11B-406.5.10 Diagonal curb ramps
Diagonal or corner type curb ramps with returned curbs or other well-defined edges shall have the edges parallel to the direction of pedestrian flow....
-
4. Shower Wand
Is there an adjustable height hand-held shower wand with at least a 60" long hose provided so persons who bathe from a seated position may wash and rinse with the directional spray?...
-
Location of Controls
Comments indicated that this specification was not consistent with a corresponding figure showing the location on the side closest to the shower opening. Response....
-
II-5.3000 Curb ramps
II−5.3000 Curb ramps....
-
4.7.1 Location
Curb ramps complying with 4.7 shall be provided wherever an accessible route crosses a curb....
-
4.7.1 LOCATION
Curb ramps complying with 4.7 shall be provided wherever an accessible route crosses a curb....
-
Common Questions (Ramps and Curb Ramps)
Common Questions
-
11B-608.2.1 Reserved
ETA Editor's Note The transfer type shower compartments prescribed by 2010 ADAS 608.2.1 are not recognized as an accessible shower in California....
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
- Redi Free® with Redi Base® Shower Pans
- Redi Free® with Redi Trench® Shower Pans
-
1. Location
Generally, you must provide curb ramps wherever a sidewalk or other pedestrian walkway crosses a curb. ...
-
11B-809.10.6.6 Controls
Controls and operating mechanisms shall comply with Section 11B-309.4.
-
1. Number of Roll-in Showers
If there are more than 50 guestrooms/suites in the facility, are the proper number of accessible rooms with roll-in showers provided per table 9.1.2 below....
-
11B-406.5.2 Width
The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 48 inches (1219 mm) minimum....
-
2 [§§ 4.7.2; 4.8.2; 4.1.6(3)(a)]
2 [§§ 4.7.2; 4.8.2; 4.1.6(3)(a)] The running slope of the curb ramp is the slope in the direction that people travel when going up or down the ramp run....
-
1 [§ 4.7.3]
1 [§ 4.7.3] Only measure the width of the ramp section of the curb ramp (labeled “ramp” to the right [below]). The ramp section of a curb ramp is also known as the “ramp run.”...
-
11B-608.2.3 Alternate roll-in type shower compartments
11B-608.2.3 Alternate roll-in type shower compartments....
-
11B-608.2.3 Alternate roll-in type shower compartments
Alternate roll-in type shower compartments shall be 36 inches (914 mm) wide and 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
§35.151(e)
(e) Curb ramps....
-
608.1 General
Shower compartments shall comply with 608. Advisory 608.1 General....
-
608.1 General
Shower compartments shall comply with 608. Advisory 608.1 General....
-
Wet Conditions: ADA Standard Section 405.10
Section 405.10 covers the current ADA Standards for wet conditions at ramp landings.