Clear space: A grid 72 inches long by 90 inches wide was used to facilitate the recording of space requirements for each WMD user (Figure 1)....
Search Results "Figures"
Filters
Commonly Searched Documents
-
Clear space
-
2.3.2. Device Acquisition
The device acquisition calculation is diagrammed in Figure 2-3....
-
2.2. Total Costs
The methodology for combining the components of the total costs is presented in Figure 2-1 below. ...
-
5.4.7 Transfer Support Gripping Surface Clearance Recommendation for M301 and M302
This clearance location is around the cross section of the gripping surface (see Figure 5.4.7). NPRM Proposed Provision: Gripping surface clearance not addressed....
-
5.4.2 Transfer Support Length for M301 and M302
This is a linear measurement (see Figure 5.4.1). NPRM Proposed Provision: Length not addressed....
-
3.3.10 90-Degree Turn
The width required for all participants to complete a 90-degree turn in our sample was much smaller than the UDI findings (Figure 3‒10), due to differences in the abilities of people or/...
-
Station 4-Acceleration
The acceleration data were collected using time-stamped video to determine the elapsed time for the participants accelerating along a 61-m (200-ft) section of the course (figure 34)....
-
11B-705.1.1.2 Dome spacing
ETA Editor's Note This Figure has not been updated to reflect the text at 11B-705.1.1.1 regarding dome height. DSA-AC's Advisory Manual still has this same Figure....
-
11B-802.1.3 Depth
Figure 11B-802.1.3 (b) depicts a single wheelchair space with side entry....
-
11B-802.1.3 Depth
Figure 11B-802.1.3 (b) depicts a single wheelchair space with side entry....
-
605.2 Height and Depth
Figure 605.2 Height and Depth of Urinals...
-
505.7.2 Non-Circular Cross Sections
Figure 505.7.2 Handrail Non-Circular Cross Section...
-
802.2.1.1 Lines of Sight over Heads
[ECTCR UFAS 4.33.3] Figure 802.2.1.1 Lines of Sight over the Heads of Seated Spectators...
-
11B-802.2.2.1 Lines of sight over heads
FIGURE 11B-802.2.2.1 LINES OF SIGHT OVER THE HEADS OF STANDING SPECTATORS...
-
802.1.3 Depth
Figure 802.1.3 Depth of Wheelchair Spaces in Assembly Areas...
-
11B-406.5.8 Counter slope
FIGURE 11B-406.5.8 COUNTER SLOPE OF SURFACES ADJACENT TO CURB RAMPS...
-
604.3.1 Size
[ECTCR UFAS 4.16.2, Fig. 28, 4.34.5.2(1), Fig. 47(a)] Figure 604.3.1 Size of Clearance at Water Closets...
-
605.2 Height and Depth
[ECTCR UFAS 4.18.2] Figure 605.2 Height and Depth of Urinals...
-
Adjustable height/gap protocol
initial setup, a gap separating the device and platform was introduced with the plywood blocks of 3.5” (8.9cm) and then the height of platform was adjusted incrementally higher/lower (Figure...
-
609.2.2 Non-Circular Cross Section
Figure 609.2.2 Grab Bar Non-Circular Cross Section...
-
604.5.1 Side Wall
Figure 604.5.1 Side Wall Grab Bar at Water Closets...
-
302.3 Openings
Figure 302.3 Elongated Openings in Floor or Ground Surfaces ...
-
904.3.2 Counter
Figure 904.3.2 Check-Out Aisle Counters...
-
11B-505.10.2 Top extension at stairs
FIGURE 11B-505.10.2 TOP HANDRAIL EXTENSION AT STAIRS...