During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed...
Search Results "Seating Space"
Commonly Searched Documents
-
M305.2.3 Height
-
M305.2.6 Gripping Surface
Transfer support gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides. The bottoms of transfer support gripping surfaces...
-
M305.2.6 Gripping Surfaces (Section-by-Section Analysis)
The proposed rule did not provide any specific requirements regarding gripping surfaces on transfer supports. However, in the MDE NPRM preamble the Access Board repeatedly noted that...
-
M305.2.3 Height (Section-by-Section Analysis)
In the MDE NPRM there was no specific requirement regarding the height of the transfer support, only that it be “within reach” of the patient (proposed M305.2.1). The Access Board...
-
M305.2.4 Cross Section (Section-by-Section Analysis)
The proposed rule did not provide specific requirements for the cross section of transfer supports. However, in the MDE NPRM preamble, the Access Board noted that it was considering...
-
5.4.9 Interruptions along Transfer Support Gripping Recommendation for M301 and M302
5.4.9 Interruptions along Transfer Support Gripping Recommendation for M301 and M302 Description: Transfer supports may contain elements to provide structural support or prevent...
-
5.4.5 Transfer Support Position Recommendation for M301 and M302
5.4.5 Transfer Support Position Recommendation for M301 and M302 Description: Transfer support position refers to the placement of the gripping surface within the minimum and...
-
5.4.2 Transfer Support Length for M301 and M302
5.4.2 Transfer Support Length for M301 and M302 Description: Transfer support length applies to the gripping surface of the support, that portion of the support used to grasp or...
-
5.3 Transfer Sides
5.3 Transfer Sides.
-
5.3 Transfer Sides Recommendations
5.3 Transfer Sides Recommendations
-
M305.2.1 Location
Transfer supports shall be located within reach of the transfer surface and shall not obstruct transfer onto or off of the surface when in position.
- SciFit PRO1000 - Seated Upper Body Machine
- Access Board: General Accessible Parking Requirements
-
1011.2.1 Size and Location
The size and location of the clear ground space shall be in accordance with Table 1011.2.1. ...
-
Section A: Parking
If more than 25 parking spaces are provided to voters, see the 2010 Standards for the number of accessible parking spaces required. (§208.2) Yes No N/A Comments/Remedies...
-
9.5.2(2)(c)
(c) at least one toilet room for each gender or one unisex toilet room shall have a minimum clear door width of 32 in (815 mm), minimum turning space complying with 4.2.3, one water closet...
-
§ 36.302(f)(6) Hold and release of accessible seating
(6) Hold and release of accessible seating. ...
- American Standard AquaWash Telescoping Bidet Seat 5900A.05G
-
Sell-outs in specific seating areas. (Section-by-Section Analysis)
Under the second contingency, proposed § 36.302(f)(6)(ii), a facility could release unsold accessible seating in a specific seating area if all of the standard seats in that location were...
-
Sell-outs in specific seating areas. (Section-by-Section Analysis)
Under the second option, § 35.138(f)(2), a facility could release unsold accessible seating in a specific seating area once all of the standard seats in that location were sold out. ...
-
Release of unsold accessible seats. (Section-by-Section Analysis)
Proposed § 36.302(f)(6) provides regulatory guidance regarding the release of unsold accessible seats. ...
-
Re: DSA Drawing 11B-406-1C Curb Ramp Adjoining a Parking Access Aisle next to a Curb and Gutter (2016 CBC)
If the slope of the gutter is greater than 1:48, can they merely show it outside of the required 18' deep accessible parking space and access aisle?...