paragraph (b) of Sec.36.201 reiterates the general principle that both the landlord that owns the building that houses the place of public accommodation, as well as the tenant that owns or operates...
Search Results "Operation (Control)"
-
Section 36.201(b) (Preamble, Section-by-Section Analysis)
-
Section 36.201(b) (Section-By-Section Analysis and Response to Comments)
paragraph (b) of Sec.36.201 reiterates the general principle that both the landlord that owns the building that houses the place of public accommodation, as well as the tenant that owns or operates...
- DORMA 8900 Series Door Closer
- Norton Surface Mounted 7900 Series Overhead Door Closer
- Moen Delaney with MotionSense Spot Resist Stainless One-Handle High Arc Pulldown Kitchen Faucet
-
607.4.2.1 Back Wall
Each grab bar shall be 24 inches (610 mm) long minimum and shall be installed 24 inches (610 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall....
-
11B-407.2.1.4 Location
A destination-oriented elevator system provides lobby controls enabling passengers to select floor stops, lobby indicators designating which elevator to use, and a car indicator designating...
-
607.4.1.1 Back Wall
Each grab bar shall be installed 15 inches (380 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall. [ECTCR UFAS 4.34.5.4(3), Fig. 48(b)]...
-
703.4.1 Height above Finish Floor or Ground
[ECTCR UFAS 4.30.6] EXCEPTION: Tactile characters for elevator car controls shall not be required to comply with 703.4.1....
-
604.9.6 Dispensers
Dispensers shall not be of a type that controls delivery or that does not allow continuous paper flow....
-
Set the Automatic Volume Adjustment
If volumes are adequate in quiet conditions, but do not increase enough or quickly enough when ambient noise increases, the microphone sensitivity, or automatic gain control, may need to...
-
11B-607.4.2.1 Back wall
Each grab bar shall be 24 inches (610 mm) long minimum and shall be installed 24 inches (610 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall....
-
607.4.2.1 Back Wall
Each grab bar shall be 24 inches (610 mm) long minimum and shall be installed 24 inches (610 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall....
-
28.1 Q. If an architect or builder chooses to follow the bathroom specifications in Requirement 7...are the other bathrooms in the dwelling unit required to have reinforced walls for grab bars?
The same would be true for other Requirements in the Guidelines, such as Requirement 5, which applies to usable light switches, electrical outlets, thermostats and other environmental controls...
-
608.2.2.1 Clearance
EXCEPTION: A lavatory complying with 606 shall be permitted on one 30 inch (760 mm) wide minimum side of the clearance provided that it is not on the side of the clearance adjacent to the controls...
-
Rehabilitation Act Amendments
mandate presumptive employability, meaning applicants should be presumed to be employable unless proven otherwise, and state that eligible individuals must be provided choice and increased control...
-
Information technology (Preamble, Section-by-Section Analysis)
the Clinger-Cohen Act, that is, any equipment or interconnected system or subsystem of equipment, that is used in the automatic acquisition, storage, manipulation, management, movement, control...
-
11B-407.2.1.4 Location
A destination-oriented elevator system provides lobby controls enabling passengers to select floor stops, lobby indicators designating which elevator to use, and a car indicator designating...
-
11B-703.5.6 Height from finish floor or ground
Exceptions: Visual characters indicating elevator car controls shall not be required to comply with Section 11B-703.5.6....
-
11B-607.4.2.1 Back wall
Each grab bar shall be 24 inches (610 mm) long minimum and shall be installed 24 inches (610 mm) maximum from the head end wall and 12 inches (305 mm) maximum from the control end wall....
-
§ 36.301(b) Safety
A public accommodation may impose legitimate safety requirements that are necessary for safe operation....
-
234.4.2 Minimum Number
Where the structural or operational characteristics of an amusement ride are altered to the extent that the amusement ride's performance differs from that specified by the manufacturer or...
-
Sec.36.301(b) Safety
A public accommodation may impose legitimate safety requirements that are necessary for safe operation....