The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
Search Results "Minimum Dimension"
Filters
Commonly Searched Documents
-
Accessible Routes
-
Accessible Routes
Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
-
Cashier counters
Provide a section of counter that is a minimum of 36" wide by a maximum of 36" high or an auxiliary accessible counter at the following locations: i....
-
Wheelchair Storage Space
The space must be a minimum of 30 inches by 48 inches. For safety reasons, this space may not overlap any required means of egress or an accessible route....
-
904.4 Sales and Service Counters
the number of existing counters at work stations or a reduction of the number of existing mail boxes, the counter shall be permitted to have a portion which is 24 inches (610 mm) long minimum...
-
5.8.3 Breast Platform Recommendations
The height of the breast platform shall be 30 inches high minimum and 42 inches high maximum above the floor when in use by a patient seated in a wheelchair...
-
R309.3 Perpendicular or Angled Parking Spaces
Where perpendicular or angled parking is provided, an access aisle 2.4 m (8.0 ft) wide minimum shall be provided at street level the full length of the parking space and shall connect to...
-
221.2.1.1 General Seating
Table 221.2.1.1 Number of Wheelchair Spaces in Assembly Areas Number of Seats Minimum Number of Required Wheelchair Spaces 4...
-
1132A.6 Closer-effort to operate doors
When fire doors are required, the maximum effort to operate the door may be increased to the minimum allowable by the appropriate enforcement agency, not to exceed 15 pounds (66.7 N)....
-
407.12.2.2 Obstructed Side Reach (Section-by-Section Analysis)
operable part is located more than 10 inches, but not more than 24 inches, behind the vertical reference plane, the height of the operable part must be 46 inches maximum and 15 inches minimum...
-
4.10.13* Car Position Indicators
Numerals shall be a minimum of 1/2 in (13 mm) high. The audible signal shall be no less than 20 decibels with a frequency no higher than 1500 Hz....
-
10.3.1(16)
(16) Where provided in below grade stations, escalators shall have a minimum clear width of 32 inches....
-
General [5.1]/ Access Aisles [5.3]
The required clear width (36 inches minimum) is specified for the clearance between the edges of fixed tables or between table edges and walls....
-
232 Detention and Correctional Facilities
correctional facilities shall comply with the 2010 Standards except that public entities shall provide accessible mobility features complying with section 807.2 of the 2010 Standards for a minimum...
-
4.10.13* CAR POSITION INDICATORS
Numerals shall be a minimum of 1/2 in (13 mm) high. The audible signal shall be no less than 20 decibels with a frequency no higher than 1500 Hz....
-
Required Number [§208]
On sites with multiple parking facilities, the minimum number of accessible spaces must be calculated separately for each parking facility instead of on the combined total of parking spaces...
-
Error/Omission: No van accessible spaces are provided in the parking area.
Requirement: 4.1.2 (5)(b) One in every eight accessible spaces, but not less than one, shall be served by an access aisle 96 in (2440 mm) wide minimum and shall be designated "van accessible...
-
11B-405.9.2 Curb or barrier
A curb, 2 inches (51 mm) high minimum, or barrier shall be provided that prevents the passage of a 4 inch (102 mm) diameter sphere, where any portion of the sphere is within 4 inches (102...
-
11B-703.5.6 Height from finish floor or ground
Visual characters shall be 40 inches (1016 mm) minimum above the finish floor or ground. Exceptions: 1....
-
11B-809.10.4 Sufficient maneuvering space
Where doors swing into the toilet and bathing or powder rooms required to comply with Section 11B-809.10, a clear maneuvering space of 30 (762 mm) inches by 48 inches (1219 mm) minimum shall...
-
Door and Gate Hardware: ADA Standard Section 404.2.7
Section 404.2.7 covers the current ADA Standards for door and gate hardware.
-
11B-213.3.1 Toilet compartments
Full-height partitions and door assemblies can comprise toilet compartments where the minimum required spaces are provided within the compartment. ◼...
-
Section 36.311 Mobility Devices (Section-by-Section Analysis)
The dimensions, weight, and other characteristics of the mobility device in relation to a wheelchair or scooter, as well as the device's maneuverability and speed, may be considered. ...