The clear floor area width dimension also informs the minimum clearance width for successful passage through corridors, doorways, and wheelchair ramps....
Search Results "Hinge Side Clearance"
-
Clear Floor Space: Minimum Clear Floor Space Required - Manual, Power & Scooter
-
§ 38.77(b)
Handrails shall be placed to provide a minimum 11/2 inches knuckle clearance from the nearest adjacent surface....
-
Bradley Plastic Baby Changing Station
961 – Grey and White Speckled Model 9611 – Solid Light Grey Model 9612 – Ivory Product Materials Molded bacterial-resistant, high density polyethylene with fulllength, steel hinge...
-
ASI Storage Solutions Angle Frame Locker
double-, and six-tier configurations Durable 14 gauge doors 2 mil powder coated in any of 15 designer colors 16 gauge bottom shelf for durability Continuous full-length staked piano hinge...
-
Hussey Seating Company Roll-A-Way Seating
Four swivel casters are mounted on hinged plates to either fold underneath for easy mobility or fold up out of the way when secured to the floor....
-
902 Dining Surfaces and Work Surfaces
Some commenters also recommended a higher minimum height of 29 inches instead of 28 inches to allow a more comfortable knee clearance. Response....
-
Boat Slips: ADA Standard Section 235.2
Section 235.2 covers scoping requirements in the current ADA Standards for boat slips.
-
11B-221.2.3.2 Vertical dispersion
Vertical, center, or side aisles adjoining bleacher seating that are stepped or tiered are not considered entry points. ◼ Advisory 11B-221.2.3.2 Vertical dispersion Exception 2....
-
11B-221.2.3.2 Vertical dispersion
Vertical, center, or side aisles adjoining bleacher seating that are stepped or tiered are not considered entry points. ◼ Advisory 11B-221.2.3.2 Vertical dispersion Exception 2....
-
Section H: Lifts
If a side door/gate is provided, is the clear opening width at least 42"? (§410.6) ...
-
406.7 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
Entry Points and Seats
Consider design features like open sides, back supports, and hand supports (right) to help facilitate easy transfer and access....
-
1003.2.12.2 Opening limitations
Exception: The triangular opening formed by the riser, tread and bottom rail at the open side of a stairway shall be of a maximum size such that a sphere of 6 inches (152mm) in diameter...
-
Clear Deck Space
This space must be located on the side of the seat opposite the water. The slope of the clear deck space must not be greater than 1:48 (2%)....
-
R305.1.4 Size
At curb ramps and blended transitions, detectable warning surfaces shall extend the full width of the ramp run (excluding any flared sides), blended transition, or turning space....
-
704.11.1 Parapet construction
Parapets shall have the same fire-resistance rating as that required for the supporting wall, and on any side adjacent to a roof surface, shall have noncombustible faces for the uppermost...
-
General [9.1.1]
Where room numbers are provided, they must be raised and Brailled and located on the wall at the latch-sides of doors for safety and uniformity....
-
11B-308.4 Suggested reach ranges for children
These dimensions apply to either forward or side reaches. ...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
105.2.2 ASME
that at least two flat steps be provided at the entrance and exit of every escalator and that steps on escalators be demarcated by yellow lines 2 inches wide maximum along the back and sides...
-
105.2.2 ASME
that at least two flat steps be provided at the entrance and exit of every escalator and that steps on escalators be demarcated by yellow lines 2 inches wide maximum along the back and sides...
-
AJW Architectural Products U646 Series Lever Operated Roll Towel Dispenser & Waste Receptacle Combination - Recessed
Hinge: Full length, stainless steel piano type hinge. Locks: Pin tumbler commercial quality lock, Collars: Fabricated of #22 ga stainless steel, finished to match cabinet....
