When possible, include both “horizontal” (side to side) and “vertical” (front to back) aisles to improve access and flow....
Search Results "Hinge Side Clearance"
Filters
Commonly Searched Documents
-
Best Practice Recommendations for Layout Planning
-
11B-704.4.1 Height
accessible telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side...
-
604.7 Dispensers
If toilet paper dispensers are installed above the side wall grab bar, the outlet of the toilet paper dispenser must be 48 inches (1220 mm) maximum above the finish floor and the top of...
-
404.2.3 Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms
Ramps with drop offs ½ inch or greater shall provide edge protection 2 inches high minimum on each side....
-
R208.2 Where Not Required
required at cut-through pedestrian refuge islands that are less than 1.8 meters (6.0 ft) in length because detectable warning surfaces must extend 610 millimeters (2.0 ft) minimum on each side...
-
Orientation (slide 12)
But there are a lot of buildings where [separation is provided by] an area rug or a change of floor color: “that’s the furnished area that’s [the waiting area] right adjacent or to one side...
-
Areas of sport activity. (Section-by-Section Analysis)
In court sports, the accessible route would also have to directly connect both sides of the court. ...
-
402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared sides...
-
A4.30.1 GENERAL
People can generally distinguish signage within an angle of 30 degrees of either side of the centerline of their face without moving their head....
-
404.2.3 Doorways - Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
404.2.3 Doorways - Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
III-7.5185 Automated teller machines
The ADAAG standard now in effect provides that ATM's must meet the requirements for both a forward and a side approach....
-
Calculation of Percentages
For example, for the location of wheelchair accessible water closets (16” – 18” centerline from side walls or partitions), specifying to the midpoint of the range (17”) will accommodate...
-
1.1.6 Flatness of walk cross slope
measurement is based on the assumption that most accessible exterior walks will be at least 60 in. (1525 mm) wide due to passing requirements and that users will tend to stay toward one side...
-
11B-404.2.3 Clear width
In alterations, a projection of 5/8 inch (15.9 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
11B-404.2.3 Clear width
Exceptions: In alterations, a projection of 5/8 inch (15.9 mm) maximum into the required clear width shall be permitted for the latch side stop....
-
1133A.4.1 Repositionable countertops
The sides of adjacent cabinets and the back wall, which may become exposed to moisture or food handling when a countertop is lowered, shall be constructed of durable, nonabsorbent materials...
-
11B-809.10.6.1 Size
11B-809.10.6.1 or; A shower stall 36 inches (914 mm) deep by 60 inches (1524 mm) wide minimum with an entrance 36 inches (914 mm) minimum when a wall is installed on the opening side...
-
Activar JL Industries 1900 Series Dual AED & Emergency Oxygen Recessed or Surface-Mounted Cabinet
Door: Formed door with 1-1/4” trim, mounted in a 5/8” door stop attached by a continuous hinge. ...
-
Ronick Matting Systems BaseMat 300 Entrance Floor Mat
The entrance floor mats feature aluminum hinged framework with cushioned supports at the bottom of each segment....
-
Bobrick Koala Kare Horizontal, Stainless Steel Wall Mounted Baby Changing Station KB110-SSWM
Full length steel-on-steel hinges with 11 gauge steel mounting bracket eliminating plastic wear points and providing superior child protection and durability....
-
Lift-U® Fold-Out Rising Floor Ramp
Gaps in floor when deployed – minimal Hinge Knuckles between Ramp & Bus structure – eliminated SPECIFICATIONS Clear width at ramp surface – 30 Inches Minimum...
