These stops include transfer points with other fixed routes....
Search Results "Side Transfer"
Commonly Searched Documents
-
Section 37.167 Other Service Requirements
-
Reassignment
to take a job.(79) The employer, however, would have to provide an employee with a disability who is being reassigned with any training that is normally provided to anyone hired for or transferred...
-
Expert Report of Douglas J. Anderson, RAS, CASP, LCM Architects (August 8, 2018)
Sidewalks & Walkways: The exterior ramp does not include handrails on each side of the ramp (1991 ADA Stds 4.8.5; 2010 ADA Stds 405.8, 505.2)....
-
Polling place violations that can be remediated with temporary measures
Building Entrance: The pull side of the entrance door does not provide at least 18 inches clearance to the side of the latch (1991 ADA Stds 4.13.6, Fig. 25; 2010 ADA Stds 404.2.4)...
-
Expert Report of Ken Schoonover, P.E., KMS Associates, Inc. (August 7, 2018)
Hallways & Corridors: The pull side of the interior door does not provide at least 18 inches clearance to the side of the latch (1991 ADA Stds 4.13.6, Fig. 25; 2010 ADA Stds 404.2.4)...
-
GENERAL CONSIDERATIONS FOR TRAFFIC SIGNAL CONTROLLED ROUNDABOUT PEDESTRIAN CROSSINGS
However, in both cases, the installations stopped both entrance and exit sides of the signalized leg at the same time....
-
2.3.3 Comparison of Dimensions with Standards and other Anthropometric Studies
• Circular and T-shaped Wheelchair Turning Space: Compared to the maneuvering clearances required to make a 180-degree turn in a space confined on three sides....
-
Issue: Historically Significant Facilities
An accessible side entrance was added to this historic facility....
-
2. Shoulder Breadth
However, space for tasks such as turning over to the side when reclining is not being considered....
-
R208.1 Where Required
Boarding and alighting areas at sidewalk or street level transit stops for rail vehicles where the side of the boarding and alighting areas facing the rail vehicles is not protected by screens...
-
Technical Memorandum TM 2017-25 Door and Gate Surfaces
Effective Date: April 1, 2017 2012 TAS Reference: 404.2.10 404.2.10 requires door and gate surfaces within 10 inches (255mm) of the finish floor to have a smooth surface on the push side...
-
Self-Reported Disability Types Demographics
Ambulatory Dysfunction (n=1) Guillian-Barre Syndrom (GBS) (n=1) Reflex sympathetic dystrophy (n=1) Side...
-
Tread Obstacles on Outdoor Recreation Access Routes
Treads that are just wide enough for one-way traffic could have a handrail on one side. Two handrails may be needed if stairs are provided in hightraffic areas....
-
Taking Measurements
Place the end of the tape measure on the side of the door frame next to the clear opening (as shown in the drawing). Stretch the tape across the door opening to the face of the door....
-
Kitchen Appliances and Fixtures
Side-hinged oven door/breadboard below for wheelchair users....
-
4.3.5.1 90-Degree Turn
The other side of each leg had moveable walls. The enclosed space was incrementally increased until a user could pass through the turn successfully....
-
1.1.13 Flatness of ramp running slope
Each line should be approximately 6 in. (150 mm) from the inside (ramp side) edge of the handrail....
-
Examination Tables
Some power tables have armrests, grab rails, side rails, and cabinets or drawers....
-
Introduction
Objects that project into circulation spaces from the side or that do not provide at least 80 inches of head clearance can be extremely hazardous to people who are blind or who have low...
- AJW Architectural Products U1304 Series 56 oz. Unidoor Horizontal Liquid Soap Dispenser - Recessed
- Mockett SDH1-SSS Sliding Door Hardware Set
- DORMA ED700 Low-Energy Swing Door Operator
- GE® 24" Standard Clean Free-Standing Electric Range JAS02SNSS