People can generally distinguish signage within an angle of 30 degrees of either side of the centerline of their face without moving their head....
Search Results "Non-public Facing Content"
-
A4.30.1 GENERAL
-
404.2.3 Doorways - Clear Width
Clear openings of doorways with swinging doors shall be measured between the face of the door and the stop, with the door open 90 degrees....
-
404.2.3 Doorways - Clear Width
Clear openings of doorways with swinging doors shall be measured between the face of the door and the stop, with the door open 90 degrees....
-
3-D Shape Digitization
The first such instrument used by the Air Force was a small low- density laser scanner which rapidly passed over the head and face and, in combination with computer graphics software, produced...
-
Tips for Attendees
When faced with event or hotel staff who fail to understand your requests or their responsibilities, use this guide to help explain their legal obligations....
-
11B-602.6 Water flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
11B-404.2.3 Clear width
Clear openings of doorways with swinging doors shall be measured between the face of the door and the stop, with the door open 90 degrees....
-
11B-404.2.3 Clear width
Clear openings of doorways with swinging doors shall be measured between the face of the door and the stop, with the door open 90 degrees....
-
11B-602.6 Water flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
604.8.1.4 Toe Clearance
partition and at least one side partition shall provide a toe clearance of 9 inches (230 mm) minimum above the finish floor and 6 inches (150 mm) deep minimum beyond the compartment-side face...
-
404.2.3 Clear Width
Clear openings of doorways with swinging doors shall be measured between the face of the door and the stop, with the door open 90 degrees....
-
602.6 Water Flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
F214.1 General
Washers and dryers provided for use by employees during non-work hours are not considered to be provided in employee work areas. ...
-
§382.127(c)
(c) If the battery on the passenger's wheelchair or other similar mobility device has been labeled by the manufacturer as non-spillable as provided in 49 CFR 173.159(d)(2), or if a battery-powered...
-
F.4 - If an agency has appropriately determined and documented that commercial items are not available that meet applicable technical provisions, must it also determine that an exception applies?
(In other words, when a product meeting the standards is commercially available, it is treated no differently than a non- commercial item with respect to application of the undue burden...
-
Handrails [§405.8, §505]
Handrails can have circular or non-circular cross-sections, but must have rounded edges. The gripping surface and adjacent surfaces must be free of abrasive or sharp elements....
-
Test Procedures
Samples of EWF will be obtained from each surface for moisture content determination immediately following the impact testing....
-
Anthropometry of Wheeled Mobility Project - Final Report
The contents of the report do not necessarily represent the policy of the U.S. Access Board or NIDRR, and readers should not assume any endorsement by the Federal government....
-
Don-Jo Mfg., Inc. Commercial Kick Plates 90
605, 606, 609, 612, 613, 619, 626, 628, 629, 630, 670, BT, DB, EN Fastenerss #6 x 5/8" SMS Options MAG - magnetic backing for metal doors, SM - double face...
-
Rooted in Rights
Our content supports efforts to defend and advocate for the rights of people with disabilities and empowers our audience to create change through online and offline advocacy. ...
-
I. Slip Resistant Surface—Aisles, Steps, Floor Areas Where People Walk, Floor Areas in Securement Locations, Lift Platforms, Ramps
While the dynamic coefficient of friction during walking varies in a complex and non-uniform way, the static coefficient of friction, which can be measured in several ways, provides a close...
-
11B-216.4.1 Exit doors
exit passageway is a horizontal exit component that is separated from the interior spaces of the building by fire-resistance-rated construction and that leads to the exit discharge or public...
