Building Entrance: The slope in the maneuvering clearance at the exterior entrance exceeds 1:48 (1991 ADA Stds 4.5.2, 4.13.6; 2010 ADA Stds 305.2, 404.2.4.4)....
Search Results "Latch Side Clearance"
Filters
Commonly Searched Documents
-
Expert Report of John Rife Torkelson, theACCESSpartnership, L.P. (August 8, 2018)
-
Stair widths
I am having an issue on a project that has 42" high guardrails (due to a >30" drop off on either side) which are spaced exactly 48" apart....
-
11B-1009.5.7 Grab bars
Grab bars shall comply with Section 11B-609 and be located on at least one side of the transfer system. The grab bar located at the transfer platform shall not obstruct transfer....
-
B. What Is a Curb Ramp?
Flared sides, or flares, bring the curb itself to the level of the street....
-
1009.5.7 Grab Bars
Grab bars shall comply with 609 and be located on at least one side of the transfer system. The grab bar located at the transfer platform shall not obstruct transfer....
-
Combination Wheelchair/Horse Accessible Gates
Wheelchairs are able to go into the center of the gate, turn around and go out the other side. Horses can walk over the two stiles....
-
604.7 Dispensers
If toilet paper dispensers are installed above the side wall grab bar, the outlet of the toilet paper dispenser must be 48 inches (1220 mm) maximum above the finish floor and the top of...
-
Temporary Solutions For Emergency Sheltering - Ramps
Suggestion: Install a portable ramp with a slope no steeper than 1:12 with edge protection and handrails on both sides of the ramp....
-
Are carriers required to provide wheelchair service from the curb to the airplane or only from the ticket counter to the airplane?
it is advisable to ask a friend or a cab driver to help in getting the attention of carrier personnel in the terminal to obtain the required assistance if the carrier does not have curb-side...
-
A4.30.1 General
People can generally distinguish signage within an angle of 30 degrees to either side of the centerlines of their faces without moving their heads....
-
2.4 False Detections
On each of the white, brown, and asphalt side walks, each participant experienced two trials in which there was a flat blank panel on the sidewalk instead of a bumpy detectable warning....
-
M101.2 Application
The technical criteria in M302 for diagnostic equipment used by patients in a seated position; and in M301 for diagnostic equipment used by patients in a supine, prone, or side-lying position...
-
11B-704.4.1 Height
accessible telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side...
-
11B-704.4.1 Height
accessible telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side...
-
4. Example: Installing Curb Ramps for Program Accessibility
The accessible entrance to the town hall is located on North Street, which is on the north side of the building....
-
11B-221.1 General
At least five percent of aisle seats (but not less than one) are required to either have no armrest on the aisle side or to have a removable or folding armrest on the aisle side....
-
Shower Compartments
Alternate roll-in showers are 36 inches wide by 60 inches long minimum, and have a 36-inch minimum wide opening on the long side of the compartment....
-
Slopes and Resting Intervals for Beach Access Routes
1:20 (5 percent) 1:12 (8.33 percent) 50 feet (15 meters) 1:12 (8.33 percent) 1:10 (10 percent) 30 feet (9 meters) Cross slopes—the side-to-side...
-
Appendix Two: Design Information and Accommodation Models
Study findings on Armrest height, calculated as the mean height of the four corner points of the arm rest on the right side measured from the floor....
-
11B-221.1 General
At least five percent of aisle seats (but not less than one) are required to either have no armrest on the aisle side or to have a removable or folding armrest on the aisle side....
-
11B-221.1 General
At least five percent of aisle seats (but not less than one) are required to either have no armrest on the aisle side or to have a removable or folding armrest on the aisle side....
-
11B-226.1 General
Consider work surfaces that are flexible and permit installation at variable heights and clearances....
-
Viewing Scopes [1011.2, 1011.3, and 1011.8]
Knee and toe clearance that complies with section 306 of the ABA Standards must be provided under the viewing scope (figure 25)....