For example, X-ray equipment that is designed for use in a standing position for certain procedures would have to meet the technical criteria for slip resistant standing surface and standing...
Search Results "Reflecting Surface"
Filters
Commonly Searched Documents
-
4. Organization of Technical Criteria
-
Section 37.139 Plan Contents
The final rule contains a reorganized and slightly expanded section on plan contents, reflecting requests to be more explicit, rather than less explicit....
-
Commercial Facilities in Private Residences (Preamble, Section-by-Section Analysis)
This approach is reflected in § 36.401(b)(1)....
-
Devices or Methods for Notification of Other Emergencies
The guests place the stands directly in front of themselves and adjust the screens so they can see the reader board reflected off the screens....
-
Analysis of impact on small entities.
The proposals reflect the Department's analysis and review of complaints or comments from the public as well as changes in technology. ...
-
Analysis of impact on small entities.
The proposals reflect the Department's analysis and review of complaints or comments from the public as well as changes in technology. ...
-
Attitudes
Staff discussion and self-reflection B....
-
6. RECEIVERS AND COUPLERS: RECOMMENDATIONS
The recommendations given below reflect the comments and suggestions made, but also represent our own best judgements: • The ALS receiver should be capable of delivering speech at levels...
-
Commercial Facilities in Private Residences (Section-By-Section Analysis and Response to Comments)
This approach is reflected in Sec.36.401(b)(1)....
-
11B-604.9 Water closets and toilet compartments for children's use
The following table provides additional guidance in applying the specifications for water closets for children according to the age group served and reflects the differences in the size,...
-
11B-604.9 Water closets and toilet compartments for children's use
Table 11B-604.9 provides additional guidance in applying the specifications for water closets for children according to the age group served and reflects the differences in the size, stature...
-
QUESTION: WHAT CONSTITUTES AN ALTERATION TO A PLATFORM FOR PURPOSES OF TRIGGERING THE APPLICATION OF SECTION 37.42 REQUIREMENTS?
For example, if the platform height relative to the top of rail is raised, if the old surface is removed and/or a new surface put down, or if there is a reconstruction of or structural change...
-
Scoping [4.1.2(1), 4.1.3(1)] and Location [4.3.2]
Clear width, surface texture, running and cross slope, and the treatment of changes in level help determine the usability of walking surfaces by people with mobility impairments....
-
1016.5 Obstacles
The vertical alignment of joints in concrete, asphalt, or board surfaces on outdoor recreation access routes can be obstacles....
-
Purpose of the project
For instance, when this project began, tolerances for the measurement of the slope, flatness, and smoothness of exterior walking and rolling surfaces in concrete, asphalt, unit masonry,...
-
Clearance Around Base (M301.4.2 and M302.4.2)
M302.4.2 would require the base of the equipment to provide a clearance 6 inches high minimum measured from the floor and 36 inches deep minimum measured from the edge of the examination surface...
-
§ 38.159(b)(13) Handrails
The handrail shall have a cross-sectional diameter between 11/4 inches (32 mm) and 11/2 inches (38 mm) or shall provide an equivalent grasping surface, and have eased edges with corner radii...
-
§ 38.29(b)
Handrails shall have a cross-sectional diameter between 11/4 inches and 11/2 inches or shall provide an equivalent grasping surface, and have eased edges with corner radii of not less than...
-
VOR
In developing principles that reflect individual differences, VOR rejects a “broad brush” approach to rights and principles which apply to most individuals with disabilities, but not all...
-
11B-704.5 TTY shelf
The telephone handset shall be capable of being placed flush on the surface of the shelf....
-
704.5 TTY Shelf
The telephone handset shall be capable of being placed flush on the surface of the shelf....
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
-
1013.1 General
Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
-
I. Introduction
The purpose of this Minority Report is to make a formal recommendation for a minimum transfer surface low height of 19 inches for diagnostic imaging medical equipment....
