Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline of the markings. ...
Search Results "Designated Aisle Seat (Assembly)"
Commonly Searched Documents
-
11B-502.1 General
-
11B-502.1 General
Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline of the markings....
- Wireless RERC: Accessibility, Usability, and the Design of Wearables and Wirelessly Connected Devices
- Pilot Rock XT and XTH Series End Accessible Picnic Table Using Aluminum
- Pilot Rock UT and UTH Series End Accessible Aluminum Picnic Table
-
4.3.5 Patient Positions During Diagnostic Imaging
Some nuclear medicine (NM) equipment has a unique design created for convenience: in this design, the table pivots out of the way to allow a scan of a patient seated in a chair or wheelchair...
-
407.12 Reach Height
This provision allows operable parts of ICT to be designed to be reached by a person seated in a wheelchair from a forward or side position, depending upon the design....
-
Sec.36.403(c)(1)(iii)
(iii) Redesigning the assembly line area of a factory; or...
-
§ 36.403(c)(1)(iii)
(iii) Redesigning the assembly line area of a factory; or...
-
11B-812.1 General
Where vehicle spaces and access aisles are marked with lines, measurements shall be made from the centerline of the markings....
-
11B-812.1 General
Where vehicle spaces and access aisles are marked with lines, measurements shall be made from the centerline of the markings....
-
1. INTRODUCTION
Over 90 years ago, some Churches in Denmark were using wired systems that led from a microphone on the pulpit to earphones located at designated seats within the sanctuary....
-
Conclusions
It focuses solely on the adequacy of these transfer surface dimensions for a static seating surface....
-
11B-1009.2 Pool lifts
There are a variety of seats available on pool lift. Pool lift seats with backs enable a larger population of persons with disabilities to use the lift....
- Pilot Rock WPTS Square Frame Table Using Recycled Plastic
- Pilot Rock WPTS Square Frame Table Using Lumber
-
4.1.6(3)(d)
(i) 4.6, Parking and Passenger Loading Zones, (ii) 4.15, Drinking Fountains and Water Coolers, (iii) 4.25, Storage, (iv) 4.28, Alarms, (v) 4.31, Telephones, (vi) 4.32, Seating...
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
4.1.3 Adjustable Height Chairs with and without Footplates
a minimum 2” clearance is required from the floor to the bottom of the footplate as specified by domestic UL and International Electrotechnical Commission (IEC) standards (as currently designed...
-
Safe Harbor
The 2010 Standards for assembly areas contain revised requirements for dispersion of accessible seating, sightlines over standing spectators, and companion seating....
-
F234.1 General
These requirements apply generally to newly designed and constructed amusement rides and attractions....
-
234.1 General
These requirements apply generally to newly designed and constructed amusement rides and attractions....
-
234.1 General
These requirements apply generally to newly designed and constructed amusement rides and attractions....
-
TABLE OF CONTENTS
Bathtubs 4.21 Shower Stalls 4.22 Toilet Rooms 4.23 Bathrooms, Bathing Facilities, and Shower Rooms 4.24 Sinks 4.25 Storage 4.26 Handrails, Grab Bars, and Tub and Shower Seats...