Search Results "Viewing Angle"
-
American Standard Right Width 1.28-1.6 gpf FloWise Right Height Elongated Flushometer Toilet Side View
-
American Standard Madera 1.6 gpf ADA EverClean Toilet with Exposed Manual Flush Valve System Side View
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
R408.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
Maneuvering Clearances at Doors [4.13.6]
Maneuvering through doors is often done on an angle, particularly at doors with closers, and the minimum space required is also dependent on how the door may be approached....
-
504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
Appendix D: Photometric Measurements
All measurements were made at an angle of 45 degrees relative to the horizontal test surface looking in the same direction that the participants viewed the detectable warnings during their...
-
Measures and Procedures
The angle between the WMD and the transfer station is defined from 0°-180°....
-
504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
11B-812.7.1 Location
Exception: Where four or fewer total EVCS are provided within a facility, the access aisle for non-angled van accessible spaces may be located on either the driver or passenger side of the...
-
Transfer Surface Size – M301.2.2 Supine, Prone, or Side-Lying Position
Podiatry Chair, Side View Podiatry Chair, Top View Dental Chair, Side View Dental Chair, Top View...
-
11B-703.8.9 Height above floor
Low resolution VMS characters shall be 40 inches (1016 mm) minimum above the floor of the viewing position, measured to the baseline of the character....
-
11B-703.8.9 Height above floor
Low resolution VMS characters shall be 40 inches (1016 mm) minimum above the floor of the viewing position, measured to the baseline of the character....
-
A4.2.1(2) Space Requirements for Use of Walking Aids
Crutch tips, often extending down at a wide angle, are a hazard in narrow passageways where they might not be seen by other pedestrians....
-
A4.2.1(2) Space Requirements for Use of Walking Aids
Crutch tips, often extending down at a wide angle, are a hazard in narrow passageways where they might not be seen by other pedestrians....
-
Van Space: Wider Parking Space
Where a van space and regular accessible space share an aisle, it is advisable to have the access aisle serve the van space on the passenger side (as is required where van spaces are angled...
-
Toilet Room Configuration
The 450 angle facilitated maneuvering by eliminating the need for sharp turns in small spaces....
-
Scoping Requirements
The scoping requirements for outdoor constructed features are explained in the sections of the standards that contain the scoping requirements for camping and picnic facilities, viewing...
-
Appendix A to Part 382—Report of Disability-Related Complaint Data
View or download PDF (page 1) View or download PDF (page 2)...
-
INTERNATIONAL SYMBOL OF ACCESSIBILITY
It is a graphic representation of the profile view of a wheelchair with occupant. See Chapter 11B, Figure 11B-703.7.2.1. ◼...
-
INTERNATIONAL SYMBOL OF ACCESSIBILITY
It is a graphic representation of the profile view of a wheelchair with occupant. See Chapter 11B, Figure 11B-703.7.2.1. ◼...
-
221 Assembly Areas
Vertical dispersion shall not be required in assembly areas with 300 or fewer seats if the wheelchair spaces provide viewing angles that are equivalent to, or better than, the average viewing...
