The standards listed in F105.2 are incorporated by reference in this document and are part of the requirements to the prescribed extent of each such reference....
Search Results "FTDS: Federal Trail Data Standards"
Filters
Commonly Searched Documents
-
F105.1 General
-
105.1 General
The standards listed in 105.2 are incorporated by reference in this document and are part of the requirements to the prescribed extent of each such reference....
-
[2010 ADAS] 105.1 General
The standards listed in 105.2 are incorporated by reference in this document and are part of the requirements to the prescribed extent of each such reference....
-
Trailheads
[See subsections ...]
-
7.4.3.2 Cross Slope
The cross slope shall not exceed 1:20 (5 percent). Where the surface is paved or is elevated above the natural ground, the cross slope shall not be steeper than 1:48 (2 percent).
-
What does "accessible" mean?
A site, facility, or program either meets the requirements of the Federal accessibility standards and guidelines or it does not meet the requirements and is not accessible....
-
Managed Use
Managed Use is an FTDS term for the mode(s) of travel for which a trail is actively managed....
-
12113(b) Qualification Standards
(b) Qualification Standards....
-
12113(b) Qualification standards
(b) Qualification standards The term "qualification standards" may include a requirement that an individual shall not pose a direct threat to the health or safety of other individuals...
-
ANSI
[DSA-AC] The American National Standards Institute....
-
Pit Toilets [F213.1, Exception]
Pit toilets on trails and in camping facilities are not required to comply with the scoping and technical requirements for toilet facilities....
-
Sec. 12207. Federal wilderness areas. [Section 508]
[See subsections ...]
-
7.4.5.3 Non-complying Segment Ends
Where a segment of the trail does not comply with 7.4, a passing space shall be located at the end of each adjacent trail segment that does comply with 7.4....
-
E202.3 Federal Contracts (Section-by-Section Analysis)
E202.3 Federal Contracts (Section-by-Section Analysis) This section proposes that ICT acquired by a contractor that is incidental to a contract would not be required to conform to this...
-
Does the Americans with Disabilities Act (ADA) apply to the Forest Service?
Except for the section that applies to Federal wilderness areas, the programs and facilities of Federal agencies are NOT governed by the Americans with Disabilities Act (ADA) of 1990....
-
Section 504
104.23(c), new construction or alterations made in conformance with the Uniform Federal Accessibility Standards (UFAS) are deemed to be in compliance with Education's Section 504 regulations...
-
C102.6 International Standards Organization (ISO)
Copies of the referenced standards, may be obtained from International Organization for Standardization, ISO Central Secretariat, 1, ch. de la Voie-Creuse, CP 56 - CH-1211 Geneva 20, Switzerland...
-
E102.6 International Standards Organization (ISO)
Copies of the referenced standards may be obtained from International Organization for Standardization, ISO Central Secretariat, 1, ch. de la Voie-Creuse, CP 56 - CH-1211 Geneva 20, Switzerland...
-
Standards and Anthropometry for Wheeled Mobility
Standards and Anthropometry for Wheeled Mobility REPORT PREPARED FOR: U.S....
-
Foot Travel on Trails and Roads With Restrictions
When gates, barriers, or berms are installed on a trail or a road to close it to motorized traffic or for other purposes, but foot travel is encouraged beyond the closure, people who use...
-
ANSI Standard
The 1980 edition of that standard was based on research funded by the Department, and became the basis for the Uniform Federal Accessibility Standards (UFAS), published in the Federal Register...
-
7.4.7 Openings
Openings in trail tread surfaces, trail resting spaces, and trail passing spaces shall be small enough to prevent passage of a 1/2 inch- (13 mm-) diameter sphere....
-
Installation of Aggregate Surfaces at Bradford Woods
Native soil shall be blended into the last 3-inch lift of crushed rock to soften the color and texture of the finished trail tread....
-
1017.7 Slopes
The slopes of trails shall comply with 1017.7....