(f) If an escalator or stair is planned or installed where none existed previously and major structural modifications are necessary for such installation, then a means of accessible...
Search Results "Elevator Door Timing"
Filters
Commonly Searched Documents
-
4.1.6(1)(f)
-
Allegion Glynn-Johnson Push/Pull Latches
Glynn-Johnson has been providing the highest quality door control hardware for 75 years. Glynn-Johnson uses only state-of-the-art technology and manufacturing processes....
-
Cal-Royal Legacy Series Locksets
Square corner face plate and 5" round corner backsets optional Option 3 Hour Fire Rated UL Listed Latch ANSI Standard A156.2 Grade 3 Fits 1-3/8" to 1-3/4" wood or metal doors Round...
-
TownSteel MS Series, Grade 1 With "W" Escutcheon Mortise Locks
It's specially designed to cover extra holes of exiting door prep....
-
§ 36.401(d)(3)
(3) The elevator exemption set forth in this paragraph (d) does not obviate or limit, in any way the obligation to comply with the other accessibility requirements established in paragraph...
-
Sec.36.401(d)(3)
(3) The elevator exemption set forth in this paragraph (d) does not obviate or limit, in any way the obligation to comply with the other accessibility requirements established in paragraph...
-
§100.205(a)
(a) Covered multifamily dwellings for first occupancy after March 13, 1991 shall be designed and constructed to have at least one building entrance on an accessible route unless it...
-
Technical Memorandum TM 2013-19 Private Toilet and Bathing Rooms
, private toilet and bathing rooms and the plumbing fixtures and accessories provided in these rooms shall comply with TAS 603 and all other applicable provisions of TAS at the initial time...
-
Time periods
Time Periods Paragraphs (c) and (d) establish time periods for complying with the program accessibility requirement....
-
TownSteel CSRC Series, Grade 2, Clutched, Conical Rose Cylindrical Locks
Specification: Door Thickness 1-3/8”-2” (35mm-51mm) Backset 2-3/4” standard. 2-3/8”, 3-3/4” and 5” optional Strike ASA Strike standard, T-Strike Optional Latch bolt Stainless steel...
-
TownSteel CB Series, Grade 2 Non-Clutched Flat Rose Cylindrical Locks
Specification: Door Thickness 1-3/8”-2” (35mm-51mm) Backset 2-3/4” standard. 2-3/8”, 3-3/4” and 5” optional Strike ASA Strike standard, T-Strike Optional Latch bolt Stainless steel...
-
Activar Hiawatha 5-1/2P Series Pull with Matching Push Plate
Cast Pull Combined with Coordinating Push Plate Gives Your Door A Finished Look and a Durable Finish. The most popular Hiawatha pull plate combinations are shown here....
-
Figure 404.2.4.1(a) Maneuvering Clearances at Manual Swinging Doors and Gates: Front Approach, Pull Side – Drawing from the U.S. Access Board
-
Allegion Schlage LT Series Mechanical Locks with Tubular Interconnect
Safety and security are paramount when choosing door hardware, but continuity in design is also key for those projects that require enhanced aesthetic appeal....
-
(2) An accessible route into and through covered dwelling units
The final Guidelines distinguish between (i) single-story dwelling units, and (ii) multistory dwelling units in elevator buildings, and provide guidance on designing an accessible entrance...
-
T504 Passenger Access Routes
[See subsections ...]
-
CHAPTER 5: DOORWAYS, CIRCULATION PATHS AND FARE COLLECTION DEVICES
[See subsections ...]
-
T503 Passenger Access Routes
In the 2016 Non-Rail Vehicle Guidelines, passenger access routes (which were referred to as “accessible circulation paths” in the proposed rule) must provide clearances sufficient to...
-
F. Chapter 5: Doorways, Circulation Paths, and Fare Collection Devices
Chapter 5 in the 2016 Non-Rail Vehicle Guidelines contains the technical requirements for doorways, illumination at doorways and boarding and alighting areas, passenger access...
-
4.1.6(4)(e)
(e) Toilet rooms. Where alterations to existing facilities make strict compliance with 4.22 and 4.23 structurally impracticable, the addition of one "unisex" toilet per floor...
-
Stanley QCL 200 Series Grade 2 Standard Duty Cylindrical Locks
Certifications ANSI/BHMA A156.2 Series Grade 2 ANSI A117.1 Accessibility Code (ADA Compliant) UL/cUL listed(3-hours) for "A" label single door applications (4' x 8...
-
DORMA C800 Series Lockset
Easy installation DORMA C800 Series locksets are easy to install in both wood and hollow metal doors with ANSI/BHMA Standard A156.115 preparations for cylindrical locks....
-
Stanley QCI 200 Series Grade 2 Standard-Duty Interconnected Locks
two (2) ball bearings inserted to prevent drill attacks ADA thumbturn Certifications ANSI/BHMA A156.12 - 1999 Grade 2 UL/cUL listed (3-hours) for "A" label single door...
-
TownSteel XCE9010 Cylindrical Lockdown Rigid Trim Keypad Cylindrical
Specifications Application: For classroom lockdown, full indoor and outdoor User/Office code capacity per lock : 90 Emergency code capacity per lock: 9 Remote Control Unit (RCU) verification time...
