Changes in height greater than ½ inch (12.7 mm) shall be accomplished by means of a ramp complying with Section 1114A or by means of a platform constructed to the level of the floor as illustrated...
Search Results "Input Floor"
Commonly Searched Documents
-
1132A.4, Item 3
- Door King Inc. 1802 and 1802-EPD Electronic Programmable Directory Telephone Entry System
- Unity Surfacing Systems Soft-Land Rubberized Safety Surfacing
- Ampetronic MLD7 MultiLoop Driver Hearing System
- Ampetronic MLD5 MultiLoop Driver Hearing System
-
Text Telephones (TTY)
Section 217.4.2 of the 2010 Standards requires that a building or facility provide a public TTY on each floor that has four or more public telephones, and in each telephone bank that has...
-
RECOMMENDED CHANGE
medical devices, requires a similar instability test in section 9.4.2.3: ME EQUIPMENT having a mass of 25 kg or more, other than FIXED ME EQUIPMENT that is intended to be used on the floor...
-
Examination Tables
Treatment tables typically have a fixed height of 31 inches measured from the floor to the top of the table. The lower cost products have an open base with an H-brace or shelf....
-
II-6.2100 General
If ADAAG is chosen, however, public entities are not entitled to the elevator exemption (which permits certain buildings under three stories or under 3,000 square feet per floor to be constructed...
-
Minimum Rear Wall Required.
Using the 2010 ADA Standards for Accessible Design, the minimum bench length would be 42" and the width of the clear floor space adjacent to the end of the bench would be 30"....
-
Existing elevator cab size
Requires the Accessibility Specialist plan or above. (Login or upgrade your account!)
-
Question: Alteration vs. Maintenance for Stairs in Pre-ADA Building
The site in question is a large, pre-ADA building with retail on the ground floor and offices (not public accomodations) on the second floor....
-
a. Structural Strength
The Access Board sought input in question 18, on whether current transfer supports are capable of resisting vertical and horizontal forces of 250 pounds at all points....
-
Executive Order 13132: Federalism
The Department also solicited and received input from public entities in the September 2004 ANPRM and the June 2008 NPRM....
-
1134A.8, Item 1
The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor....
-
Water Play Components
If the surface of the accessible route, clear floor or ground spaces, and turning spaces that connect play components are submerged, the accessible route does not have to comply with the...
-
407.8.2.2 Obstructed Side Reach
more than 24 inches (610 mm), beyond the vertical reference plane, the height of the operable part shall be 46 inches (1170 mm) high maximum and 15 inches (380 mm) high minimum above the floor...
-
4.27.3* Height
Electrical and communications system receptacles on walls shall be mounted no less than 15 in (380 mm) above the floor....
-
5.5 Food Service Lines
Tray slides shall be mounted no higher than 34 in (865 mm) above the floor (see Fig. 53)....
-
Plumbed Fixtures
Non-fixed units, such as bottled water coolers, are recognized as an option in providing additional access where only one fixed unit is provided on a floor....
-
1134A.8, Item 1
The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor....
-
11B-608.5.1 Reserved
compartments, the controls, faucets, and shower spray unit shall be installed on the side wall opposite the seat 38 inches (965 mm) minimum and 48 inches (1220 mm) maximum above the shower floor...
-
(1)(c)
long should be mounted on at least one side wall, with one end not more than 12 inches (305 mm) from the back wall, at a height between 33 inches (840 mm) and 36 inches (915 mm) above the floor...
-
PUBLIC-USE AREAS
Examples of public use areas may include a hotel lobby, movie theater, concert hall, public restroom, sales floor of a retail store, or dining room within a restaurant.◼...