If the Department is unable to reach a satisfactory resolution of the issue or issues raised within 30 days of the date it provides notice to SDA, it may institute a civil action in federal...
Search Results "Side Reach"
-
IMPLEMENTATION AND ENFORCEMENT
-
4.3.4 Knee and Toe Clearances
Hence, to accommodate a particular percentage of users, the side profile of a design element (shown by dotted line) should not extend outside the corresponding shaded area....
-
4.3.3 Clear Floor Area
For example, when designing an alcove at the side of a large open space where the length of a device must be addressed but the width is not an issue because there is plenty of room to one...
- Pilot Rock TQ700 Square Frame Square Utility Table
- Allegion Falcon SC60 Series Surface Mounted Door Closer
- Delta H2Optics Exposed Flush Valve 81T201BTA
- Pilot Rock T700 Square Frame Rectangular Utility Table
- Interface Whole Earth Collection WE151 Carpet Tiles
- Accessible Icon Project
- Perkins School for the Blind
- Easterseals Delaware & Maryland's Eastern Shore
- National Autism Association
- SSB Bart Group
- LD OnLine
- Supporting Students with Hearing Impairments: Tools, Technology and Key Resources
-
Section 1193.37 Information pass-through [1193.27 in the NPRM] (Section-by-Section Analysis)
In addition, manufacturers objected to the one-sided nature of the requirement and wanted manufacturers of peripheral devices and specialized customer premises equipment to be held accountable...
-
Designated Aisle Seats
a) of the 1991 Standards requires one percent (1%) of fixed seats in assembly areas to be designated aisle seats with either no armrests or folding or retractable armrests on the aisle side...
-
11B-404.2.7 Door and gate hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides. [Safe Harbor only applies to existing primary entrances.]...
-
Exercise Equipment and Machines
If the clear space is enclosed on three sides (e.g., by walls or the equipment itself), the clear space must be at least 36 by 48 inches....
-
Passing Spaces [1016.4]
T-shaped space extend a minimum of 48 inches beyond the intersection (figure 12) Either of these configurations provides enough space for people using mobility devices to move to the side...
-
Requirement 6. Reinforced walls for grab bars.
Where the toilet is not placed adjacent to a side wall, the bathroom would comply if provision was made for installation of floor mounted, foldaway or similar alternative grab bars....
-
Alternative Designs. Bathroom as Shower Room
This turned out not to be the case, and a retrofit with an after-market in-line valve installed on the upstream side of the coupling turned out to be impractical due to the danger of backflow...
-
DETR
A low profile stand was constructed with a weight pad underneath and two cameras mounted above and to the side. Participants were recruited as they walked by the apparatus....
-
Wheeled Mobility Anthropometry Project
Anthropometry Project are discussed in connection with the following technical criteria: • Height of transfer surfaces on diagnostic equipment used by patients in a supine, prone, or side-lying...