For example: An interviewer could say: "The person in this mailroom clerk position is responsible for receiving incoming mail and packages, sorting the mail, and taking it in a cart to many...
Search Results "Non-Positive Shut Off"
-
5.5(f) The Job Interview
-
Process of Determining the Appropriate Reasonable Accommodation
Although this process is described below in terms of accommodations that enable the individual with a disability to perform the essential functions of the position held or desired, it is...
- Doorbell Factory Nutone Plug-In Chime with Strobe Light & Pushbutton
- Balco Inc. IllumiTread Photoluminescent Egress Markings System
-
Section 1630.2(j)(1)(vi) Mitigating Measures
The Amendments Act provides an “illustrative but non-comprehensive list of the types of mitigating measures that are not to be considered.” See 2008 Senate Statement of Managers at 9....
-
Capacity Constraints
For example, if on a regular basis the reservation phone lines open at 5 a.m. and callers after 7 a.m. are all told that they cannot travel, or the phone lines shut down after 7 a.m. and...
- Easterseals Rehabilitation Center of Greater Waterbury
-
Boat Slips: ADA Standard Section 1003.2.1
The cross slope specified in 403.3 and 405.3 for gangways, transition plates, and floating piers that are part of accessible routes shall be measured in the static position. 8....
-
11B-1003.2.1 Boat slips
The cross slope specified in Sections 11B-403.3 and 11B-405.3 for gangways, transition plates, and floating piers that are part of accessible routes shall be measured in the static position...
-
11B-603.2.3 Door swing
Other than doors to accessible water closet compartments, a door in any position, shall be permitted to encroach into the turning space by 12 inches (305 mm) maximum....
-
11B-603.2.3 Door swing
Other than doors to accessible water closet compartments, a door in any position, shall be permitted to encroach into the turning space by 12 inches (305 mm) maximum....
-
11B-1003.2.1 Boat slips
The cross slope specified in Sections 11B-403.3 and 11B-405.3 for gangways, transition plates, and floating piers that are part of accessible routes shall be measured in the static position...
-
11B-408.4.1 Car dimensions and doors
Car doors shall be positioned at the narrow ends of cars and shall provide 32 inches (813 mm) minimum clear width. Exceptions: 1. ...
-
What should I do if my staff do not know how to help a person with a disability transfer or know what the ADA requires my office to do?
This training will need to address how to operate the accessible equipment, how to assist with transfers and positioning of individuals with disabilities, and how not to discriminate against...
-
TITLE III COVERAGE
It is the United States' position that it generally will be a reasonable modification required by title III of the ADA for certain public accommodations, such as camps and child care service...
-
404.2.7 Door and Gate Hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides. [ECTCR UFAS 4.13.9] EXCEPTIONS: 1....
-
404.2.7 Door and Gate Hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides. EXCEPTIONS: 1....
-
Introduction
Positive language empowers. When writing or speaking about people with disabilities, it is important to put the person first — to focus on the person, not the disability....
-
32. If an employer has provided one reasonable accommodation, does it have to provide additional reasonable accommodations requested by an individual with a disability?
If there is no alternative accommodation, then the employer must attempt to reassign the employee to a vacant position for which s/he is qualified, unless to do so would cause an undue hardship...
-
404.2.7 Door and Gate Hardware
Where sliding doors are in the fully open position, operating hardware shall be exposed and usable from both sides. EXCEPTIONS: 1....
-
Training requirement. (Section-by-Section Analysis)
While some groups have urged the Department to modify this position, the Department has determined that such a modification would not serve the full array of individuals with disabilities...
-
A4.4.1 GENERAL
techniques are the touch technique, where the cane arcs from side to side and touches points outside both shoulders; and the diagonal technique, where the cane is held in a stationary position...
-
Transit Stops (R308.1) (Section-by-Section Analysis)
Boarding platforms at transit stops must be positioned to coordinate with vehicles to minimize the vertical and horizontal gaps....
-
A4.4.1 General
techniques are the touch technique, where the cane arcs from side to side and touches points outside both shoulders; and the diagonal technique, where the cane is held in a stationary position...