Vehicle pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger drop-off and loading zone and from the passenger drop-off and loading zone to...
Search Results "Transfer Space"
Filters
Commonly Searched Documents
-
11B-503.5 Vertical clearance
-
B. Question 2: Section 904.4.1 and Clear Counter Space
The inquiry into whether a sales or service counter satisfies Section 904.4.1’s length requirement turns on the length of the counter as built, not on the length of “clear” counter space...
-
Additional Clearance: ADA Standard Section 306.2.4
Section 306.2.4 covers the current ADA Standards for additional clearances for toe space.
-
Appendix 3 - Comparison of US Standards to IDEA Center Research
Eye height (EH) 1090-1295 75 1174 1047 1288 Clear Floor Space...
-
703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
3. Exception to Ramp Running Slope
The MDE Advisory Committee, during its discussion of wheelchair spaces on weight scales, extensively addressed the permissible slopes of ramps on raised platforms....
-
4.2 Physical Accessibility Barriers and Solutions
Barriers Solutions Simple/Low cost Involved / High cost Parking spaces are too narrow Use cones and/or tape and temporary signs to mark...
-
11B-609.3 Spacing
The space between the wall and the grab bar shall be 1½ inches (38 mm). The space between the grab bar and projecting objects below and at the ends shall be 1½ inches (38 mm) minimum....
-
703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
M303.3.3 Ramped (Section-by-Section Analysis)
The MDE NPRM proposed that for equipment with a change in level at the entry of a wheelchair space, level changes greater than ½ inch high would be required to be ramped and comply with...
-
11B-703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
11B-703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
11B-703.4.2 Location
Where there is no wall space at the latch side of a single door or at the right side of double doors, signs shall be located on the nearest adjacent wall....
-
Whitehall Mfg. 24" Grab Bar L-Shaped Closure Plate
Model Number: 1110-1 Features: 304 stainless steel cylindrical tub construction; a L-shaped closure plate is welded on to meet Ligature-Resistant requirements. All bars are ADA...
-
Whitehall Mfg. 24" Grab Bar Flat Closure Plate
Model Number: 1109-1 Features: 304 stainless steel cylindrical tub construction; a flat closure plate is welded on to meet Ligature-Resistant requirements. All bars are ADA...
-
Mega Jailhouse Anti-Suicide Grab Bar with Closure Plate 24 inches - Concealed Mounting
Description: This 24" security / anti-suicide grab bar is fabricated in accordance with ADA specifications and is fully enclosed, thereby abating suicide risk. The grab bar is...
-
M303.1 General
Diagnostic equipment used by patients seated in a wheelchair shall comply with M303.
-
M303.3.1 Vertical
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical.
-
M303.3.2 Beveled
Changes in level between ¼ inch (6.4 mm) high and ½ inch (13 mm) high maximum shall be beveled with a slope not steeper than 1:2.
-
M303.4 Components
Where components of diagnostic equipment are used to examine specific body parts, the components shall be capable of examining the body parts of a patient seated in a wheelchair....
-
F202.6.5.5 Assembly Areas
Assistive listening systems shall comply with F219 and assembly seating shall comply with F221.
-
M303.4 Components (Section-by-Section Analysis)
The MDE NPRM proposed to require diagnostic equipment used by patients seated in a wheelchair which has components that are used to examine specific body parts, be capable of...
