identify, both objectively and subjectively, the spatial and configurational dimensions of grab-bars that effectively support both independent standing and one- and two-person assisted toilet transfers...
Search Results "Transfer Surface Height"
Commonly Searched Documents
- Mayer-Rothschild Foundation: Determination of Grab Bar Specifications for Independent and Assisted Transfers in Residential Care Settings
-
11B-1002.4.1 Floor or ground surface
The floor or ground surface of wheelchair spaces shall be stable and firm....
-
1009.4.2 Height
1009.4.2 Height. The height of the transfer wall shall be 16 inches (405 mm) minimum and 19 inches (485 mm) maximum measured from the deck. Figure 1009.4.2 Transfer Wall Height...
-
5.3.1 Permitted Obstructions to Transfer Sides for Equipment Used by Patients in a Supine, Prone, Side-Lying or Seated Position
5.3.1 Permitted Obstructions to Transfer Sides for Equipment Used by Patients in a Supine, Prone, Side-Lying or Seated Position....
-
1009.4.2 Height
The height of the transfer wall shall be 16 inches (405 mm) minimum and 19 inches (485 mm) maximum measured from the deck. Figure 1009.4.2 Transfer Wall Height...
-
Shower Compartment Seats: ADA Standard Section 610.3
Section 610.3 covers the current ADA Standards for shower compartment seats.
-
Summary of Recommendations
Summary of Recommendations
-
Transfer Systems
Transfer Systems A transfer system consists of a transfer platform and a series of transfer steps that descend into the water....
-
1009.5.3 Height
1009.5.3 Height. The height of the transfer platform shall comply with 1009.4.2....
-
Floor or Ground Surfaces: ADA Standard Section 304.2
Section 304.2 covers the current ADA Standards for the ground surfaces of a turning space.
-
M301.3.1 Transfer Supports
A.1) A transfer support will extend horizontally along the side of the patient scanning/imaging table at least the minimum width of the transfer surface, but in all cases a 28 inches minimum...
-
11B-1008.2.5.3.2 Handrail height
The top of handrail gripping surfaces shall be 20 inches (508 mm) minimum and 28 inches (711 mm) maximum above the ramp surface....
-
5.2.1.3 Transfer Surface Size Recommendations for Stretchers (M301)
5.2.1.3 Transfer Surface Size Recommendations for Stretchers (M301) The Committee recommends a minimum transfer surface size of 28 inches wide by 17 inches deep for stretchers located...
-
2004 ADA and ABA Accessibility Guidelines
The following technical criteria in the proposed standards are based on the 2004 ADA and ABA Accessibility Guidelines: • Height of transfer surfaces on diagnostic equipment used by patients...
- Smith System Trespa Planner Science Table 30″ Deep 11288
-
Counter Surface Height
Specifications are provided for the counter surface height of check-out aisles, including the height of counter edge protection, which is limited to 2 inches above the counter surface (904.3.2...
-
5.2 Transfer Surface Size for Equipment Used by Patients in Supine, Prone, or Side-Lying Position
5.2 Transfer Surface Size for Equipment Used by Patients in Supine, Prone, or Side-Lying Position....
-
11B-810.2.1 Surface
Bus stop boarding and alighting areas shall have a firm, stable surface....
-
1009.5.1 Transfer Platform
1009.5.1 Transfer Platform. A transfer platform shall be provided at the head of each transfer system....
-
1009.5.3 Height
The height of the transfer platform shall comply with 1009.4.2....
-
1009.5.3 Height
The height of the transfer platform shall comply with 1009.4.2....
-
Surface
Surface The surface of the transfer platform and steps must not be sharp and must have rounded edges to prevent injuries....
-
1009.5.1 Transfer Platform
A transfer platform shall be provided at the head of each transfer system....
- Teknion Journal Extended Range Height-Adjustable Table