[See subsections ...]
Search Results "Surface Material"
-
4.5 GROUND AND FLOOR SURFACES
-
2.2 Surface
The surface of an ORAR shall be firm and stable. The type of surface should be appropriate to the setting and level of development....
-
11B-408.4.2 Floor surfaces
Floor surfaces in elevator cars shall comply with Sections 11B-302 and 11B-303....
-
11B-408.4.2 Floor surfaces
Floor surfaces in elevator cars shall comply with Sections 11B-302 and 11B-303....
-
ADA Facilities Compliance Continuing Education Courses & Resources
ADA Facilities Compliance Continuing Education Courses & Resources by Evan Terry Associates, P.C. Click here to view/download the pdf version (121 KB) Evan Terry...
-
R404.2 Surfaces
R404.2 Surfaces....
-
Dimensional Tolerances in Construction and for Surface Accessibility
[See subsections ...]
-
T405.2 Surfaces
Step tread surfaces shall comply with T302....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
404.2.4.4 Floor or Ground Surface
404.2.4.4 Floor or Ground Surface. Floor or ground surface within required maneuvering clearances shall comply with 302. Changes in level are not permitted. EXCEPTIONS: 1....
-
Qualitative and Observational Analysis by Surface Type
Qualitative and Observational Analysis by Surface Type The aggregate material listed below contains a size (inch), the label “minus”, and an aggregate type....
-
405.4 Floor or Ground Surfaces
Floor or ground surfaces of ramp runs shall comply with 302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
405.4 Floor or Ground Surfaces
Floor or ground surfaces of ramp runs shall comply with 302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
Installation of Aggregate Surfaces at Bradford Woods
Installation of Aggregate Surfaces at Bradford Woods The installation of the aggregate surfaces at Bradford Woods conformed to the following protocol: Prior to installing the crushed...
-
4(5)
(5) Exterior deck, patio, or balcony surfaces are no more than 1/2 inch below the floor level of the interior of the dwelling unit, unless they are constructed of impervious material such...
-
R409.6 Gripping Surface
R409.6 Gripping Surface. Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
Loose Fill Surfaces
Loose Fill Surfaces. The predominant surface characteristic is one where many loose particles are combined to create the surface system. ...
-
11B-802.1.1 Floor or ground surface
The floor or ground surface of wheelchair spaces shall comply with Section 11B-302. Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted....
-
Accessible Exterior Surfaces Technical Article
Accessible Exterior Surfaces Technical Article Submitted by: Peter W. Axelson, M.S.M.E., A.T.P. Project Director Denise Chesney, M.E.B.M.E....
-
11B-902.1 General
Dining surfaces and work surfaces shall comply with Sections 11B-902.2 and 11B-902.3....
-
11B-902.1 General
Dining surfaces and work surfaces shall comply with Sections 11B-902.2 and 11B-902.3....
-
11B-302 FLOOR OR GROUND SURFACES
[See subsections ...]
-
Common Questions (Floor and Ground Surfaces)
Common Questions