The Trace Center commented that TTYs are made primarily for individuals who are deaf and requiring that TTYs provide voice output for all of the information displayed on the screen seems counter...
Search Results "Adjustable Height Counter"
-
Specialized Customer Premises Equipment (Section-by-Section Analysis)
-
III-7.3110 Work areas
Does the work area exemption apply only to areas that can be characterized as individual work stations, such as cubicles, counters, offices, or booths?...
- Atlantis Railing
- Excel Dryer, Inc. ThinAir®Hand ADA Surface Mounted Hand Dryer TA-ABS
- BTX Intelligent Fashion Motorized Drapery Systems
- Symmons SCOT® Slow-Closing Omni Temperature Lavatory Faucet S-60-H
- Symmons Temptrol II (BP Series) Shower System BP-56-500-B30-V
-
IDEA Center
Distances between points or reference planes were used to derive estimated widths, heights, and depths of key device characteristics and body dimensions....
- Rubbermaid 7818-88 Horizontal Baby Changing Station
- GameTime Bongos
- Division of Vocational Rehabilitation (DVR) - Colorado
- Lane Independent Living Alliance (LILA) - Eugene, OR
-
Standards that measure needed physical or mental ability to perform a job
Possible accommodations might include lowering the shelf-height, providing a step stool or other assistive device....
-
11B-703.3.1 Dimensions and capitalization
dots in the same cell1 0.100 (2.5 mm) Distance between corresponding dots in adjacent cells1 0.300 (7.6 mm) Dot height...
-
11B-404.2.10 Door and gate surfaces
stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (254 mm) bottom smooth surface height...
-
404.2.10 Door and Gate Surfaces
stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (255 mm) bottom smooth surface height...
-
5.4.2.2 Transfer and Positioning Support Length Recommendations for Imaging Equipment with Transfer Surfaces
A positioning support (for transfer surfaces >24” deep) is to extend horizontally along the side of the patient scanning/imaging bed/table with a length of 12 to 16 inches and a height...
-
Using the ORAR Exceptions [F202.3, Exception 4 and 1016, Exceptions 1, 2, and 3]
instance, where traffic calming devices, gates, or other barriers are provided on a paved roadway, the ORAR must have a clear width of 36 inches and obstacles cannot exceed one-half inch in height...
-
Seat Width Evaluation
seat was the smallest of the platform seat widths available in this study and was suitable for many participants (the 25th through 95th percentiles) for their level, highest and lowest height...
-
The Purpose of FSORAG and FSTAG
included (scoping); what has to comply with the guidelines; definitions of terms; and technical requirements defining the physical characteristics of accessible features, such as width, height...
-
Car Controls [4.10.12]
Alignment for a side reach is often difficult at panels on the front of cars due to the limited maneuvering space; consider a maximum height of 48 inches for panels on the front of cars....
-
4.16.6 Dispensers
As a result, the dispenser was located 24" above the floor, 5" higher than the minimum height in ADAAG, and 42" from the rear wall (Figure 13), which would have been too high and too far...
-
Additional Features of Van-Accessible Parking Spaces
Vertical clearance of 98 inches minimum to accommodate van height at the vehicle parking space, the adjacent access aisle, and on the vehicular route to and from the van-accessible space...