Examples of temporary buildings or facilities covered include, but are not limited to: reviewing stands, temporary classrooms, bleacher areas, exhibit areas, temporary banking facilities...
Search Results "Standing Surface"
-
1.9.1 Division of the State Architect - Access Compliance.
-
SHOPPING CENTER (OR SHOPPING MALL)
. ◼ ETA Editor's Note CBC defines a single, stand alone retail store as a shopping center and, therefore, requires storage mezzanines to be served by an accessible route....
-
1.9.1 Division of the State Architect - Access Compliance.
Examples of temporary buildings or facilities covered include, but are not limited to: reviewing stands, temporary classrooms, bleacher areas, exhibit areas, temporary banking facilities...
-
SHOPPING CENTER (OR SHOPPING MALL)
. ◼ ETA Editor's Note CBC defines a single, stand alone retail store as a shopping center and, therefore, requires storage mezzanines to be served by an accessible route....
- Da-Lite Global Product & Manufacturing Center ADA Lectern
- Grainger Tough Guy Stainless Steel Sanitary Napkin Receptacle, 11" Height
- GE Profileâ„¢ Series 18" Built-In Dishwasher PDW1860NSS
- San Jamar C4210PRD Pull-Type Paper/Plastic Beverage Cup Dispenser
- SciFit PRO1 - Upper Body Machine
-
Clearance
Section 403.5 specifies a continuous clearance of 36 inches minimum for walking surfaces....
-
M307.2 Tactilely Discernible (Section-by-Section Analysis)
Patients who are blind or have low vision have difficulty distinguishing a flat membrane button or similar control unless it is tactilely discernible from the surrounding surface and any...
-
904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
4.34.6.4(1)
(1) The counter shall be mounted at a maximum height of 34 in (865 mm) above the floor, measured from the floor to the top of the counter surface, or shall be adjustable or replaceable as...
-
Location and Size
The side rails are 20 inches minimum in length, 6 inches minimum in height above the table surface, and 1 inch measured horizontally from the adjacent edge of the table surface....
-
3.2 Study Limitations and Other Issues
warning surface and the luminance contrast of the warning surface with adjacent surfaces....
-
R208.1 Where Required
Detectable warning surfaces complying with R305 shall be provided at the following locations on pedestrian access routes and at transit stops: 1....
- American Standard Acrylic Seated Safety Shower
-
1132A.4 Level floor or landing
Primary entry doors, required exit doors or secondary exterior doors with changes in height between the interior surface or floor level and the exterior surface or floor level shall comply...
-
Seat Height
Commenters noted that this specification should be clarified as applying to the height as measured at the top of the seat surface. Response....
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
R405.3.3 Minimum Required Depth
Where knee clearance is required under an element as part of a clear space, the knee clearance shall be 280 mm (11 in) deep minimum at 230 mm (9 in) above the finish surface, and 205 mm...
-
Illumination Levels (Reserved) [4.30.8]
A level from 10 to 30 footcandles is recommended uniformly over the sign surface....
- seca 676 r Digital Wheelchair Scale with Handrail and Integrated RS232 Interface
-
Polypavement
After uncharacteristically heavy rainfall, the surface became the same texture as mud. Upon drying up, the surface remained cracked and was heaving along the full width of the trail....