Grab bars shall be installed 6 inches (150 mm) maximum from adjacent walls. Figure 608.3.3 Grab Bars for Alternate Roll-In Type Showers...
Search Results "Maximum Extent Practicable"
Commonly Searched Documents
-
608.3.3 Alternate Roll-In Type Shower Compartments
-
1134A.6, Item 5
When a threshold is used, it shall be a maximum of 2 inches (50.8 mm) in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from...
-
4.7.5 SIDES OF CURB RAMPS
If a curb ramp is located where pedestrians must walk across the ramp, or where it is not protected by handrails or guardrails, then it shall have flared sides; the maximum slope of the...
-
Post-Mounted Objects [§307.3]
Objects with leading edges 27” maximum or above 80” can protrude any amount from posts or pylons....
-
1134A.6, Item 5
When a threshold is used, it shall be a maximum of 2 inches (50.8 mm) in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from...
-
§ 38.159(b)(10) Platform movement
The maximum platform horizontal and vertical acceleration when occupied shall be 0.3g....
-
§ 38.153(c)(1)
The clear width may be reduced by a maximum of 4 inches (100 mm) by protrusions of hinges or other operating mechanisms....
-
11B-809.10.8.1 Location
The top of the lavatory rim shall be 34 inches (864 mm) maximum above the finished floor....
-
11B-809.10.6.5 Thresholds
Where provided thresholds shall be 2 inches (51 mm) maximum in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from the horizontal...
-
11B-809.10.6.4 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: Continuous reinforcement shall be installed in the walls of showers 30 inches (762 mm) maximum to 38 inches (965 mm) minimum...
-
11B-809.9.4 Work surfaces
Work surfaces shall be 36 inches (914 mm) maximum above the finish floor with minimum lengths at the following locations as required by this section: Linear length of 30 inches...
-
COMMERCIAL PLACE OF PUBLIC AMUSEMENT
[DSA-AC] An auditorium, convention center, cultural complex, exhibition hall, permanent amusement park, sports arena, theater or movie house for which the maximum occupancy is 2,500 or more...
-
11B-605.4 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except that the flush control shall be mounted at a maximum height of 44 inches (1118 mm) above the finish floor....
-
Fur out the wall
The centerline of the water closet shall be 16 inches (405 mm) minimum to 18 inches (455 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (430...
- Pressalit Care VALUE Support Arm Fixed Height Swing Grab Bar with Leg
- Hager Companies 5300 Series - Heavy Duty Surface Door Closer
- Landscape Structures Power Lifter™ Chinning Bar
- Hussey Seating Company Armless Chair
-
5. Do Title II and Section 504 apply to the programs, services, and activities of family courts?
proceedings, such as termination of parental rights proceedings, are state activities and services for purposes of Title II.57 Section 504 also applies to state court proceedings to the extent...
-
Equipment and furniture.
ANPRM explained that free-standing equipment was already addressed in the regulations in several different contexts, but that since covered entities continue to raise questions about the extent...
-
Benches
compliance with a specific requirement for clear floor or ground space (surface, slope, size, or location), the clear floor or ground space only has to comply with requirements to the extent...
-
A. POLICIES AND PROCEDURES
At minimum, those policies will provide that Lewisboro: will not discriminate on the basis of disability in its hiring or employment practices....
-
12101(a)(5)
exclusion, the discriminatory effects of architectural, transportation, and communication barriers, overprotective rules and policies, failure to make modifications to existing facilities and practices...
-
407.6 Status Indicators (Section-by-Section Analysis)
While new to the 255 Guidelines, status indicators for Caps Lock and Num Lock controls represent current design practice....