landing 4 feet (1219 mm) deep shall be provided at the upper end of each curb ramp over its full width to permit safe egress from the ramp surface, or the slope of the fanned or flared sides...
Search Results "Hinge Side Clearance"
-
1127B.5, Item 4
-
Hall Lanterns [4.10.4]
Up and down lantern indicators can be placed one above the other or side-by-side....
-
3.1.4.1 Width of Non-RV Campsite Vehicle Parking Areas
Where a double camping unit is provided and two parking areas are provided to accommodate two vehicles side-by-side in an accessible parking spur, the total width of the vehicle parking...
-
1009.7.2 Separation
The fire-resistance-rated exterior wall construction shall extend horizontally 10 feet (3048 mm) beyond the landing on either side of the landing or equivalent fire-resistance-rated construction...
-
11B-604.5.2 Rear wall
The rear wall grab bar shall be 36 inches (914 mm) long minimum and extend from the centerline of the water closet 12 inches (305 mm) minimum on one side and 24 inches (610 mm) minimum on...
-
A4.22.3 Clear Floor Space
It is important to keep in mind that the placement of the lavatory to the immediate side of the water closet will preclude the side approach transfer illustrated in Figure A6(b)....
-
Cassette Recordings (Advisory Guidance)
The cost of a duplicator can be higher depending upon the number of copies produced on a single run, and whether the duplicator can produce standard speed two-sided copies or half-speed...
-
11B-504.8 Floor identification
Chapter 10, Section 1023.9 complying with Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5 shall be located at the landing of each floor level, placed adjacent to the door on the latch side...
-
Kuriki 2-in-One Paper Holder
Unlike traditional designs where the surface sits above the holder, this side-by-side layout creates a more modern and practical look....
-
AJW Architectural Products U230 Series C-fold/Multifold Towel Dispenser - Recessed
gauge stainless steel with a #4 satin finish Holds 600 c-fold or 800 multifold towels Secured with pin tumbler lock, keyed like all AJW cabinets Made with heavy duty piano type hinges...
-
AJW Architectural Products U683 Dual Stall Toilet Tissue Dispenser & Sanitary Napkin Disposal - Partition Mounted
Hinges: All hinges are full length, heavy duty, stainless steel piano type hinges....
-
AJW Architectural Products U684 Series Dual Toilet Tissue Dispenser & Sanitary Napkin Disposal - Recessed
Hinges: All hinges are full length, heavy duty, stainless steel piano type hinges. Collars: #22 ga stainless steel finished to match cabinet....
-
Bobrick Surface-Mounted Medicine Cabinet B-297
Door has enameled steel piano-hinge and magnetic catch. Door is 14 1⁄8" W, 20 1⁄4" H (360 x 515mm). Unit 3 3⁄4" (95mm) deep....
-
5.1.6 Clear Floor or Ground Space
One full unobstructed side of the clear ground space shall adjoin or overlap the trail or ORAR, as applicable, or another clear ground space. ...
-
4.8.5* Handrails
If a ramp run has a rise greater than 6 in (150 mm) or a horizontal projection greater than 72 in (1830 mm), then it shall have handrails on both sides....
-
11B-610.3.1 Rectangular seats
The side edge of the seat shall be 1½ inches (38 mm) maximum from the adjacent wall....
-
A4.6.3 Parking Spaces
The increasing use of vans with side-mounted lifts or ramps by persons with disabilities has necessitated some revisions in specifications for parking spaces and adjacent access aisles....
-
Delta Widespread Lavatory Faucet 3552-MPU-DST
indicators Metal pop-up 3/8" compression fittings 2 1/4" max. deck thickness No thick deck kit available 32" minimum InnoFlex supply lines below the deck included Min. 2 1/2" clearance...
-
Telescopes and Periscopes
Provide knee and toe clearance complying with ABAAS, section 306, under the telescope or periscope (figure 98)....
-
904.3.2 Counter
The top of the counter edge protection shall be 2 inches (51 mm) maximum above the top of the counter surface on the aisle side of the check-out counter....
-
604.9.5 Flush Controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with 604.8.2....
-
604.9.5 Flush Controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with 604.8.2....
-
608.2.2 Standard Roll-In Type Shower Compartments
Standard roll-in type shower compartments shall be 30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
L. Controls
Are all drapery control wands, fixed lamps and HVAC controls in accessible guestrooms placed within 54" of the floor for side approach or 48" of the floor for forward approach so persons...
