Escalators on pedestrian circulation paths must comply with the applicable technical requirements in the 2004 ADA and ABA Accessibility Guidelines....
Search Results "Applicable Standard"
Commonly Searched Documents
-
R216 Stairways and Escalators (Section-by-Section Analysis)
-
§104.11(a)(4)
(4) A recipient may not participate in a contractual or other relationship that has the effect of subjecting qualified handicapped applicants or employees to discrimination prohibited by...
-
§104.11(b)(4)
(4) A recipient may not participate in a contractual or other relationship that has the effect of subjecting qualified handicapped applicants or employees to discrimination prohibited by...
-
12112(b)(2)
(2) participating in a contractual or other arrangement or relationship that has the effect of subjecting a covered entity's qualified applicant or employee with a disability to the discrimination...
-
§100.143(b)(2)
(2) Assess the extent and scope of any likely violation, by determining which areas of operation are likely to be affected by those policies and practices, such as stages of the loan application...
-
F244.3 Outdoor Constructed Features in Common Use and Public Use Areas
At least 20 percent, but not less than one, of each type of outdoor constructed feature provided at each location is required to comply with the applicable technical requirements in 1011...
-
F245.3 Outdoor Constructed Features in Common Use and Public Use Areas
At least 20 percent, but not less than one, of each type of outdoor constructed feature provided at each location is required to comply with the applicable technical requirements in 1011...
- TownSteel TDC 90 ALUMINUM Grade 1 Door Closer
- TownSteel TDC 70 ALUMINUM Grade 1 Door Closer
-
Section 36.403 Alterations: Path of Travel (Section-by-Section Analysis)
These commenters also stated that they did not believe there was a statutory basis for "grandfathering'' facilities that comply with the 1991 Standards....
-
II. COMPLIANCE WITH TITLE III OF THE ADA
Phase II: By January 1,2016, H&R Block shall ensure that its mobile applications conform to, at minimum, the WCAG 2.0 AA. c. ...
-
Sec. 469.052(a)
(a) The commission shall adopt standards, specifications, and other rules under this chapter that are consistent with standards, specifications, and other rules adopted under federal law...
- TownSteel XME9010 Mortise Lockdown Rigid Trim Keypad Mortise
- TownSteel FCE4010 Cylindrical Lockdown Rigid Trim
- Allegion Schlage ND Series Mechanical Locks
- TownSteel FCE4020 Cylindrical Lockdown Clutched Trim RFID Cylindrical
-
11B-607.4 Grab bars
[2010 ADA Standards] 607.4 Grab Bars. Grab bars for bathtubs shall comply with 609 and shall be provided in accordance with 607.4.1 or 607.4.2. Exceptions: 1. Reserved....
-
11B-405.5 Clear width
[2010 ADA Standards] 405.5 Clear Width. The clear width of a ramp run and, where handrails are provided, the clear width between handrails shall be 36 inches (915 mm) minimum....
-
11B-405.2 Slope
[2010 ADA Standards] EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such...
-
§382.57(c)(2) Clear floor or ground space
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
-
C. Executive Order 13132: Federalism
The MDE Standards do not impose any mandatory requirements on state and local governments....
-
§27.71(k)(2) Clear floor or ground space.
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
-
§ 27.71(k)(2) Clear floor or ground space
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...
-
§ 382.57(c)(2) Clear floor or ground space
Department of Justice's 2010 ADA Standards for Accessible Design, 28 CFR 35.104 (defining the “2010 Standards” for title II as the requirements set forth in appendices B and D to 36 CFR...