Bus shelters shall provide a minimum clear floor or ground space complying with Section 11B-305 entirely within the shelter....
Search Results "Minimum Dimension"
Filters
Commonly Searched Documents
-
11B-810.3 Bus shelters
-
Ramps
For each elevated ramp run: 12-inch (305 mm) maximum rise 1:12 maximum slope 36-inch (915 mm) minimum clear width ...
-
Seat Height
Seat Height The lift must be designed so that the seat will make a stop between a minimum of 16 inches and maximum of 19 inches (measured from the deck to the top of the seat surface,...
-
407.2.3.1 Floor Designation
Tactile characters shall be 2 inches (51 mm) high minimum. A tactile star shall be provided on both jambs at the main entry level....
-
R407.9.1 Extended Ramp Surface
The surface of the ramp run or landing shall extend 305 mm (1.0 ft) minimum beyond the inside face of a handrail complying with R409. Advisory R407.9.1 Extended Ramp Surface....
-
404.2.4 Maneuvering Clearances
Minimum maneuvering clearances at doors and gates shall comply with 404.2.4....
-
11B-505.10.1 Top and bottom extension at ramps
Ramp handrails shall extend horizontally above the landing for 12 inches (305 mm) minimum beyond the top and bottom of ramp runs....
-
11B-703.8.9 Height above floor
Low resolution VMS characters shall be 40 inches (1016 mm) minimum above the floor of the viewing position, measured to the baseline of the character. ...
-
M302.2.1 Height
The height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured from the floor to the top of the transfer surface....
-
M301.2.1 Height
The height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured from the floor to the top of the transfer surface....
-
§ 38.113(a)(1)
required to be accessible by §38.111(a) and where the spaces required by §38.111(d) of this part are located, and at least one adjacent doorway into coach passenger compartments shall have a minimum...
-
11B-703.8.9 Height above floor
Low resolution VMS characters shall be 40 inches (1016 mm) minimum above the floor of the viewing position, measured to the baseline of the character....
-
11B-605.2 Height and depth
Urinals shall be 131/2 inches (343 mm) deep minimum measured from the outer face of the urinal rim to the back of the fixture....
-
11B-605.2 Height and depth
Urinals shall be 13½ inches (343 mm) deep minimum measured from the outer face of the urinal rim to the back of the fixture. FIGURE 11B-605.2 HEIGHT AND DEPTH OF URINALS...
-
§ 36.303(g)(4)(ii)
assistive listening receivers that the public accommodation is already required to provide at its movie theaters in accordance with Table 219.3 of the 2010 Standards, if those receivers have a minimum...
-
11B-1008.2 Accessible routes
Where accessible routes serve ground level play components, the vertical clearance shall be 80 inches (2032 mm) high minimum....
-
1003.3 Clearances
Although the minimum width of the clear pier space is 60 inches (1525 mm), it is recommended that piers be wider than 60 inches (1525 mm) to improve the safety for persons with disabilities...
-
1003.3 Clearances
Although the minimum width of the clear pier space is 60 inches (1525 mm), it is recommended that piers be wider than 60 inches (1525 mm) to improve the safety for persons with disabilities...
-
T402.7 Edge Guards
Edge guards shall be 2 inches (51 mm) high minimum above the ramp or bridgeplate surface....
-
15.1 Q. If a covered multifamily dwelling has public telephones in the lobby, what are the requirements for accessibility for these telephones?
While the chart does not address the quantity of accessible public telephones, at a minimum, at least one accessible telephone per bank of telephones would be required....
-
1009.2.2 Seat Location
In the raised position, the centerline of the seat shall be located over the deck and 16 inches (405 mm) minimum from the edge of the pool....
-
§ 36.303(g)(4)(ii)
assistive listening receivers that the public accommodation is already required to provide at its movie theaters in accordance with Table 219.3 of the 2010 Standards, if those receivers have a minimum...
-
1008.4.4 Entry Points and Seats
Where play components require transfer to entry points or seats, the entry points or seats shall be 11 inches (280 mm) minimum and 24 inches (610 mm) maximum from the clear floor or ground...
-
§ 36.607 Guidance concerning model codes.
developing a model code, the Assistant Attorney General may review the relevant model code and issue guidance concerning whether and in what respects the model code is consistent with the minimum...