buildings at developed recreation sites with only one riser must comply with the requirements for toilet room size and clearances in section 603 of ABAAS and with the requirements for toilet seats...
Search Results "L-Shaped Seat"
Commonly Searched Documents
-
Toilet Buildings and Pit Toilets
- TownSteel CS Series, Grade 2, Clutched Flat Rose Cylindrical Locks
-
Storing Assistive Devices in the Aircraft Cabin
[Sec. 382.41(b)] You must permit passengers to stow their canes and other assistive devices in the cabin and close to their seats, consistent with FAA safety regulations concerning carry-on...
-
4. BUILD AN EMERGENCY NETWORK
Developing an emergency network during non-emergency times will help your community be much more prepared to respond to and recover from emergencies of all shapes and sizes. ...
-
Issues Related to the Interactive Process and Return to Work
The employer asks if the employee could do seated work during the break; the doctor says yes....
-
Accessible Routes
For each accessible amusement ride, an accessible route is required to connect to a wheelchair space, a ride seat designed for transfer, or a transfer device for use with an amusement ride...
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
For example, if an agency were to enter into a seat management contract for desktop computing resources, the hardware and software to be provided by the contractor would be required to meet...
-
Alternative Designs
The tub has a non-institutional appearance, a fold-down seat, and a swinging side entry door with a pressurized seal for ease of access....
- Caroma® USA Invisi Series II Cube Wall Hung Water Closet
- Adaptive Access
- Kompan, Inc. M175 - Water Lilies Spring Rider
- Belson Outdoors Recycled Plastic Universal Access Picnic Table
-
216 and 703 Signs
These types of signs include: seat and row designations in assembly areas; occupant names, building addresses; company names and logos; signs in parking facilities (except those identifying...
-
11B-209.4 Valet parking
Some vehicles may be adapted with hand controls or lack a driver’s seat, and may not be operable by a valet parking attendant....
-
Technical Memorandum TM 2013-11 Benches
Steam Rooms TAS 612.2 Dressing, Fitting, and Locker Rooms TAS 803.4 Holding Cells and Housing Cells TAS 807.2.2 Fixed or built-in benches and other types of fixed seating...
-
H29
Accessible Shower Stall Minimum Size and Clearances Accessible Shower Stall Grab Bars and Seat, Shower, and Control Area...
-
Access to Performing Areas [4.33.5]
While handrails are not required on ramps adjacent to assembly seating, locating aisles (including those that are stepped) along walls will permit handrails on one side for the benefit of...
-
Wheelchair Spaces
Wheelchair spaces should not overlap required exit widths or circulation paths and should provide for shoulder-to-shoulder alignment with occupants of adjacent seats (an important consideration...
-
Printable Room Layouts
If your meeting will have more than 10% of attendees using mobility devices or service animals, increase the number of accessible seating locations and aisle widths proportionally....
-
Error/Omission: When a transfer shower is used, it is often larger than the required 36" x 36" size.
Users may slide off the seat and fall onto the floor of the shower while reaching for the shower controls and hand-held showerhead. Requirement: 4.21.2 Size and Clearances....
-
1009.3.3 Area of Refuge
Areas of refuge are not required for smoke-protected or open-air assembly seating areas complying with Sections 1029.6.2 and 1029.6.3....
- Bobrick ClassicSeries Recessed Convertible Paper Towel Dispenser/Waste Receptacle B-3944
- Elkay Cane Apron LKAPREZL for use with EZ Bi-Level Drinking Fountains
- Inpro Corporation JointMaster® 925 Fire Barrier System Expansion Joint Systems