If the clear floor space allows parallel approach by a person in a wheelchair, the maximum high side reach allowed shall be 54 inches (1372 mm) and the low side reach shall be no less than...
Search Results "Maximum Dimension"
Commonly Searched Documents
-
1118B.6
-
Monitoring and Fees
$ 250,000 per year Years 6-10: $ 135,000 per year Years 11-15: $ 166,177 per year Years 16-20: $ 191,602 per year Years 21-25: $ 220,917 per year Years 26-30: $ 254,716 per year Maximum...
-
B. Summary of Major Provisions and Organization of Technical Criteria
For each category the Access Board has provided technical criteria to allow independent access to and ensure the diagnostic equipment was usable by patients with disabilities to the maximum...
-
404.2.3 Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
5.4.2 Transfer Support Length for M301 and M302
recommendation The length of the transfer support shall be a minimum of 15 inches long and positioned so that the transfer support overlaps the length of the transfer surface by 80% at a maximum...
-
Tread Obstacles [1017.5]
When the trail surface is constructed of materials other than concrete, asphalt, or boards, tread obstacles are permitted to be a maximum of 2 inches high....
-
302.2 Carpet
Pile height shall be 1/2 inch (13 mm) maximum. Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge....
-
7. APPLICABILITY
All projects before Fiscal Year 2010, regardless of the source of funds, must comply with these DoD Standards to the maximum extent feasible....
-
1003.2.12.2 Opening limitations
Exceptions: The triangular openings formed by the riser, tread and bottom rail at the open side of a stair- way shall be of a maximum size such that a sphere of 6 inches (152 mm...
-
Broad Coverage
The ADA Amendments Act of 2008 states that the definition of disability should be construed in favor of broad coverage of people to the maximum extent permitted by the law and generally...
-
302.2 Carpet
Pile height shall be ½ inch (13 mm) maximum. Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge....
-
§35.164 Duties
in such an alteration or such burdens, a public entity shall take any other action that would not result in such an alteration or such burdens but would nevertheless ensure that, to the maximum...
-
11B-604.6 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except they shall be located 44 inches (1118 mm) maximum above the floor....
-
1134A.7, Item 2
The reinforcement shall be installed a maximum of 12 inches (305 mm) from the rear wall and shall extend a minimum of 26 inches (660 mm) in front of the water closet....
-
Treads and Risers [4.9.2], Nosings [4.9.3]
ADAAG requires the height to be uniform but does not specify a minimum or maximum height which is addressed by most local building codes....
-
Technical Infeasibility
Where technical infeasibility is encountered, compliance is still required to the maximum extent technically feasible....
-
§ 35.101 Purpose and broad coverage
Amendments Act’s purpose of reinstating a broad scope of protection under the ADA, the definition of ‘‘disability’’ in this part shall be construed broadly in favor of expansive coverage to the maximum...
-
§ 38.77(c)
Particular attention shall be given to ensuring maximum maneuverability immediately inside doors. Ample vertical stanchions from ceiling to seat-back rails shall be provided....
-
11B-604.6 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except they shall be located 44 inches (1118 mm) maximum above the floor....
-
1134A.7, Item 1
The centerline of the water closet shall be 17 inches (432 mm) minimum to 18 inches (457 mm) maximum from a grab bar wall or partition....
-
1134A.7, Item 2
The reinforcement shall be installed a maximum of 12 inches (305 mm) from the rear wall and shall extend a minimum of 26 inches (660 mm) in front of the water closet....
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. [2010 ADAS] Advisory 809.2.2 Turning Space....
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. Advisory 11B-809.2.2 Turning space....