The height of water closets shall be 11 inches (280 mm) minimum and 17 inches (430 mm) maximum measured to the top of the seat....
Search Results "Minimum Dimension"
-
604.9.3 Height
-
M305.2.7 Clearance (Section-by-Section Analysis)
Specifically, the Access Board sought input from the public in question 22, on whether transfer supports on diagnostic equipment could provide 1½ inches minimum clearance around the gripping...
-
11B-604 Water closets and toilet compartments
The rear wall grab bar shall be 36 inches (914 mm) long minimum and extend from the centerline of the water closet 12 inches (305 mm) minimum on one side and 24 inches (610 mm) minimum on...
-
6.3 Minority Reports
6.3 Minority Reports Because the Advisory Committee did not achieve consensus on the recommendation for a minimum transfer surface height standard, U.S....
-
Clear Tread Width [1017.3]
The clear tread width of trails must be a minimum of 36 inches (figure 2)....
-
5.1 Transfer Surface Height Recommendations
The height of the transfer surface during patient transfer shall be 17 inches minimum and 19 inches maximum measured from the floor to the top of the transfer surface....
-
The Roles of the Access Board and the Department of Justice
The ADA requires the Access Board to "issue minimum guidelines that shall supplement the existing Minimum Guidelines and Requirements for Accessible Design for purposes of subchapters II...
-
Horizontal Alignment
This point is represented by the coefficient of friction used in the minimum design radius equations of AASHTO....
-
11B-604.5.2 Rear wall
The rear wall grab bar shall be 36 inches (914 mm) long minimum and extend from the centerline of the water closet 12 inches (305 mm) minimum on one side and 24 inches (610 mm) minimum on...
-
11B-604.5.2 Rear wall
The rear wall grab bar shall be 36 inches (914 mm) long minimum and extend from the centerline of the water closet 12 inches (305 mm) minimum on one side and 24 inches (610 mm) minimum on...
-
Bradley OmniDeck with Oval Multipurpose Basin LD3010-HS-TO1
Ready for installation, no fabrication required on-site Standard or custom dimensions to fit any application Flat bottom design maximizes basin capacity for general handwashing or...
-
Bradley OmniDeck with Rectangular Multipurpose Basin LD3010-HS-TR1
Ready for installation, no fabrication required on-site Standard or custom dimensions to fit any application Flat bottom design maximizes basin capacity for general handwashing or...
-
TrueForm 30" ADA Floating Concrete Sink Wood Edge FLO-30W-ADA
Concrete Sink meets ADA Accessibility Guidelines Dimensions: 30"L x 21"W x 5"H This floating concrete sink takes on the beautiful detail of a wood grained edge and yet still maintains...
-
Bradley OmniDeck with Square Multipurpose Basin LD3010-HS-TS1
Ready for installation, no fabrication required on-site Standard or custom dimensions to fit any application Flat bottom design maximizes basin capacity for general handwashing or...
-
New Requirements for Assistive Listening Systems (ALS)
ALSs must be capable of providing sound pressure levels of 110 dB minimum and 118 dB maximum with a dynamic volume control range of 50 dB; the signalto-noise ratio for internally generated...
-
Location and Size
The side rails are 20 inches minimum in length, 6 inches minimum in height above the table surface, and 1 inch measured horizontally from the adjacent edge of the table surface....
-
11B-604.5.1 Side wall
The side wall grab bar shall be 42 inches (1067 mm) long minimum, located 12 inches (305 mm) maximum from the rear wall and extending 54 inches (1372 mm) minimum from the rear wall with...
-
11B-604.8.1.2 Doors
Toilet compartment doors shall not swing into the minimum required compartment area....
-
11B-404.2.9 Door and gate opening force
Fire doors shall have a minimum opening force allowable by the appropriate Administrative Authority....
-
11B-404.2.9 Door and gate opening force
Fire doors shall have a minimum opening force allowable by the appropriate Administrative Authority....
-
11B-404.2.9 Door and gate opening force
Fire doors shall have a minimum opening force allowable by the appropriate Administrative Authority....
-
Character Height: ADA Standard Section 703.5.5
Minimum character height shall comply with Table 703.5.5....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
