2. U-shaped kitchens, designed with a cooktop or sink located at the base of the U, which provides a knee and toe space in accordance with Section 1133A.7 to allow for a forward...
Search Results "Emergency Transportable Housing Unit"
-
1133A.2.1, Item 2
-
1132A.3, Item 6
6. The width of any component in the means of egress system shall not be less than the minimum width required by Section 1005.
-
1133A.7, Item 2
2. The knee and toe space shall be 30 inches (762 mm) wide minimum, centered on the sink, countertop or appliance.
-
§100.5(c)
(c) Nothing in this part relieves persons participating in a Federal or Federally-assisted program or activity from other requirements applicable to buildings and dwellings.
-
1133A.7 Knee and toe space
Knee and toe space, when required by Section 1133A, shall comply with Section 1138A.2 and the following:
-
1132A.3, Item 6
6. The width of any component in the means of egress system shall not be less than the minimum width required by Section 1005.
-
1133A.7, Item 2
2. The knee and toe space shall be 30 inches (762 mm) wide minimum, centered on the sink, countertop or appliance.
-
1133A.2.1, Item 2
2. U-shaped kitchens, designed with a cooktop or sink located at the base of the U, which provides a knee and toe space in accordance with Section 1133A.7 to allow for a forward...
-
1133A.7 Knee and toe space
Knee and toe space, when required by Section 1133A, shall comply with Section 1138A.2 and the following: The knee and toe space shall be clear and unobstructed, or removable...
-
11B-809.10.8.6 Controls
Faucet controls and operating mechanisms shall comply with Section 11B-309.4.
-
11B-809.10.6.4 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: Continuous reinforcement shall be installed in the walls of showers 30 inches (762 mm) maximum to 38 inches (965 mm)...
-
11B-809.10.8.7 Mirrors and towel bars
Where mirrors are provided the bottom edge of the reflective surface shall be 40 inches (1016 mm) maximum above the finish floor. Where towel bars are provided they shall be...
-
Specific Spaces and Occupancies
Scoping provisions for specific spaces and occupancies address: Transportation Facilities (§218) and Bus Stops (§209) Assembly Areas (§221) * ...
-
Willoughby Industries WRS-BF-FA Front Mounted Recessed Shower Panel With Hand Held Flexshower Head
Unit requires no chase area for installation and maintenance....
-
11B-809.8 Doors
Primary entry doors, required exit doors, secondary exterior doors and interior doors intended for user passage shall comply with this section and Section 11B-404.2. Doors to small...
-
Access Board: Alternate Type Roll In Shower Stalls
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
7(2)(a)
(a) Bathrooms that have reinforced walls for grab bars (see Requirement 6) would meet section 100.205(c)(3)(iv) if: Note: Cabinets under lavatories are acceptable provided the...
-
11B-606.2 Clear floor space
In residential dwelling units, cabinetry shall be permitted under lavatories and kitchen sinks provided that all of the following conditions are met: (a) the cabinetry can be removed...
-
11B-606.2 Clear floor space
In residential dwelling units, cabinetry shall be permitted under lavatories and kitchen sinks provided that all of the following conditions are met: (a) the cabinetry can be removed...
-
§27.71(k)(5) Output.
(5) Output. Automated airport kiosks must comply with paragraphs (k)(5)(i) through (iv) of this section.
-
§ 27.71(k)(5) Output
(5) Output. Automated airport kiosks must comply with paragraphs (k)(5)(i) through (iv) of this section.
-
New Horizons: Information for the Air Traveler with a Disability
About this Document This guide is designed to offer travelers with disabilities a brief but authoritative source of information about the ACAA rule: the accommodations,...
-
Table 2: Summary of Department of Transportation Survey
Architectural Research Consulting 20-07 (167) No. Element surveyed Minimum reported tolerance Maximum reported tolerance Average reported...
-
F216.4.3 Directional Signs
Signs required by section 1003.2.13.6 of the International Building Code (2000 edition) or section 1007.7 of the International Building Code (2003 edition) (incorporated by...
