One accessible route connecting accessible buildings, accessible facilities, accessible elements, and accessible spaces. 11B-206.2.2 Location of accessible...
Search Results "Turning Space"
Filters
Commonly Searched Documents
-
Exterior Routes
-
Obstructions [4.7.8]
Space is needed at the top and bottom of ramps so that people using wheelchairs can align with the running slope and maneuver from ramps, including when making turns (which is difficult...
-
Employee Work Areas: ADA Standard Section 203.9
Section 203.9 covers scoping requirements of general exceptions for employee work areas in the most current ADA Standards.
-
Altered Rides
(60-inch diameter circle or T-shaped turning space) in the load and unload area must be provided....
-
11B-1008.2.3 Water play components
Exceptions: Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302,...
-
T215.1 General
Communication features on non-rail vehicles shall comply with T215.
-
T215 Communication Features
[See subsections ...]
-
1015.6 Slope
This section requires the slope of the surface of the clear ground space and turning space to not be steeper than 1:48 in any direction....
-
4.26.2* Size and Spacing of Grab Bars and Handrails
If handrails or grab bars are mounted adjacent to a wall, the space between the wall and the grab bar shall be 1‒1/2 in (38 mm) (see Fig. 39(a), (b), (c), and (e))....
-
Re: SCOTT JOHNSON v. STARBUCKS CORPORATION - AMICUS BRIEF
Providing sufficient space to allow people with disabilities to fully and equally use the counter would certainly not fundamentally alter the nature of any of these. 3) 36.304 - The obligation...
-
ATM Clear Floor or Ground Space
Sections 707.2 and 707.3 address clear floor or ground space requirements and operable parts, respectively. These provisions include exceptions for drive-up only ATMs....
-
R305.2.2 Parallel Curb Ramps
On parallel curb ramps, detectable warning surfaces shall be placed on the turning space at the flush transition between the street and sidewalk....
-
R304.5.4 Counter Slope
The counter slope of the gutter or street at the foot of curb ramp runs, blended transitions, and turning spaces shall be 5 percent maximum....
-
Feature 4 - Temporary Barrier Removal for Routes to the Meeting Space
Feature 4 - Temporary Barrier Removal for Routes to the Meeting Space...
-
Van Accessible Parking Spaces (Preamble, Section-by-Section Analysis)
- Parking spaces that can be used by people in vans (with lifts) will be required....
-
R304.5.1 Width
The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 1.2 m (4.0 ft) minimum....
-
1017.8 Resting Intervals
This section contains the technical requirements for the length (1017.8.1), width (1017.8.2), and slope (1017.8.3) of resting intervals; and for a turning space (1017.8.4) where resting...
-
1017.3 Clear Tread Width
Where gates and barriers require wheelchair users to make 90 degree or 180 degree turns, sufficient space should be provided for wheelchair users to make the turns....
-
Associated
Associated TAS 604.3.2 allows “associated” grab bars, dispensers, sanitary napkin disposal units, coat hooks, and shelves to overlap the required clearance around an accessible...
-
Sec.36.308 Seating in assembly areas
Sec.36.308 Seating in assembly areas.
-
Chapter 8: Special Rooms, Spaces, and Elements
Chapter 8 covers various types of elements, rooms and spaces, including assembly areas (802), dressing, fitting, and locker rooms (803), kitchens and kitchenettes (804), medical care and...
-
§382.65(c)(2)
(2) The chair must be designed to be compatible with the maneuvering space, aisle width, and seat height of the aircraft on which it is to be used, and to be easily pushed, pulled, and turned...