For example, Sec.4.33 of ADAAG only requires wheelchair spaces to be provided in more than one location when the seating capacity of the assembly area exceeds 300....
Search Results "Turning Space"
Filters
Commonly Searched Documents
-
Section 36.308 Seating in Assembly Areas (Section-By-Section Analysis and Response to Comments)
-
Disorienting Spaces (slide 7)
These are two images from the [research] project that Dennis talked about yesterday, where they were analyzing interior spaces that visually say one thing but really mean another....
-
Three Additional Features for Van-Accessible Parking Spaces
(plan drawing showing a van-accessible parking space with a 96 inch wide designated parking space, a 96 inch wide min. marked access aisle and the following notes) Sign with...
-
Sec.36.308(a) Existing facilities
(a) Existing facilities.
-
4.34.5.5 SHOWERS
If a shower is provided, it shall have the following features:
-
Surface and Slope [1015.5 and 1015.6]
The surface of clear ground spaces and turning spaces must be firm and stable....
-
1015.5 Surface
This section requires the surface of the clear ground space and turning space to be firm and stable....
-
Must van accessible spaces be restricted to van use?
The required "van-accessible" designation is informative, not restrictive, in identifying those spaces that are better suited for van use and does not restrict the use of spaces to vans...
-
CHAPTER 8: SPECIAL ROOMS, SPACES AND ELEMENTS
CHAPTER 8: SPECIAL ROOMS, SPACES AND ELEMENTS...
-
DIVISION 8: SPECIAL ROOMS, SPACES, AND ELEMENTS
DIVISION 8: SPECIAL ROOMS, SPACES, AND ELEMENTS...
-
CHAPTER 8: SPECIAL ROOMS, SPACES, AND ELEMENTS
CHAPTER 8: SPECIAL ROOMS, SPACES, AND ELEMENTS...
-
DIVISION 8: SPECIAL ROOMS, SPACES, AND ELEMENTS
DIVISION 8: SPECIAL ROOMS, SPACES, AND ELEMENTS...
-
Elevator Car Requirements [§407.4]
Alternative configurations that provide unobstructed wheelchair turning space (60” diameter circle or T-turn) with the doors closed are permitted....
-
407.12.3.2.2 Knee and Toe Space (Section-by-Section Analysis)
407.12.3.2.2 Knee and Toe Space (Section-by-Section Analysis) This section proposes dimensions for knee and toe space under ICT when an obstructed forward reach is provided....
-
B. Information about the Aircraft
You should be familiar with and be able to provide information about aircraft accessibility for passengers with a disability when they request this information. [Secs. 382.21 and...
-
Figure M4: Overview of M303 Diagnostic Equipment for Use by a Patient While Seated in a Wheelchair and M304 Diagnostic Equipment for Use by a Patient in a Standing Position (Weight Scale Example)
Where the primary use of the equipment supports more than one patient position, it must comply with the requirements for each use. The weight scale is usable by both people who are...
-
4.26.2* SIZE AND SPACING OF GRAB BARS AND HANDRAILS
If handrails or grab bars are mounted adjacent to a wall, the space between the wall and the grab bar shall be 1-1/2 in (38 mm) (see Fig. 39(a), (b), and (c))....
-
11B-233.3.1.2.6.5 Additional requirements.
1. Grab bar reinforcement complying with Sections 11B-809.10.5.2, 11B-809.10.6.4, or 11B-809.10.7.3. 2. Interior door opening width complying with Section 11B-404.3.1. 3....
-
1005 Fishing Piers and Platforms
Specifications for fishing piers and platforms address accessible routes, railings, edge protection, clear floor space, and turning space....
-
Figure 705.1 Size and Spacing of Truncated Domes – Drawing from the U.S. Access Board
-
11B-406.5.9 Clear space at diagonal curb ramps
The bottom of diagonal curb ramps shall have a clear space 48 inches (1219 mm) minimum outside active traffic lanes of the roadway....
-
11B-406.5.9 Clear space at diagonal curb ramps
The bottom of diagonal curb ramps shall have a clear space 48 inches (1219 mm) minimum outside active traffic lanes of the roadway....
-
11B-406.5.9 Clear space at diagonal curb ramps
The bottom of diagonal curb ramps shall have a clear space 48 inches (1219 mm) minimum outside active traffic lanes of the roadway....
-
1010 Shooting Facilities with Firing Positions
This section requires turning space at firing positions required to be accessible....
