A clear floor space complying with Section 11B-305 positioned for a forward approach shall be provided. Knee and toe clearance complying with Section 11B-306 shall be provided....
Search Results "Wheelchair Space (Transportation)"
Commonly Searched Documents
-
11B-902.2 Clear floor or ground space
-
Q5: Effective Date for Public Entities to Comply
Q5: The Joint Technical Assistance is silent on when it becomes effective. Is there an effective date for when States and local public entities must comply with the requirements...
-
Brief Answers
Yes, the replacement of a staircase is an alteration under the ADA and DOT’s implementing regulations because a staircase replacement is tantamount to the renovation,...
-
Accessible Web Sites
[See subsections ...]
-
How are the ADA standards developed?
The ADA charges the Access Board with the responsibility of developing guidelines for accessible design that are intended to serve as the basis for mandatory and enforceable ADA...
-
1015.5 Surface
The surface of clear ground spaces and turning spaces shall be firm and stable....
-
1015.5 Surface
The surface of clear ground spaces and turning spaces shall be firm and stable....
-
4.34.2(2)
(2) Accessible spaces shall have maneuvering space complying with 4.2.2 and 4.2.3 and surfaces complying with 4.5....
-
R404.6 Approach
One full unobstructed side of a clear space shall adjoin a pedestrian access route or adjoin another clear space....
-
§ 35.151(g) Assembly areas
(g) Assembly areas. Assembly areas subject to the proposed standards shall comply with the provisions applicable to assembly areas, including, but not limited to, sections 221 and...
-
§ 35.151(g) Assembly areas.
(g) Assembly areas. Assembly areas subject to this section shall comply with the provisions of the 2010 Standards applicable to assembly areas, including, but not limited to,...
-
11B-805.4.2 Equipment
Clear space complying with Section 11B-305.2 shall be provided as required for specific equipment....
-
Medical examinations, screening and monitoring required by other laws
Department of Transportation for interstate bus and truck drivers, railroad engineers, airline pilots and air controllers; The Occupational Safety and Health Act: The Federal...
-
Transfer Protocols
He was a bilateral amputee that used a power wheelchair. He was 57 years old with a height and weight of 73 inches and 285 lbs respectively. ...
-
§ 382.40a Boarding assistance for large aircraft
The agreement shall be made available, on request, to representatives of the Department of Transportation....
-
4.1.6 Surface
The surface of the clear floor or ground space shall be firm and stable. The type of surface should be appropriate to the setting and level of development. ...
-
Assessment factors. (Section-by-Section Analysis)
The term ‘‘in relation to a wheelchair'' in the NPRM's factor 1 apparently created some concern that the same legal standards that apply to wheelchairs would be applied to other power-driven...
-
Width: ADA Standard Section 502.3.1
Section 502.3.1 covers the current ADA Standards for the required width of access aisles.
-
11B-502.3.1 Width
Access aisles serving car and van parking spaces shall be 60 inches (1524 mm) wide minimum....
-
6.3(3)
(3) Each bedroom shall have adequate space to provide a minimum clear floor space of 36 in (915 mm) along each side of the bed and to provide an accessible route complying with 4.3.3 to...
-
4.6.6 Surface
The surface of the clear floor or ground space required by section 4.6.4 shall be firm and stable. The type of surface should be appropriate to the setting and level of development. ...
-
10.2.1(2)
(2) Where provided, new or replaced bus shelters shall be installed or positioned so as to permit a wheelchair or mobility aid user to enter from the public way and to reach a location,...
- Access Board: Clear Floor or Ground Space
-
Technical Memorandum TM 2013-12 Number of Accessible Elements and Spaces
TM 2013-12 Number of Accessible Elements and Spaces Effective Date: June 1, 2013 2012 TAS Reference: 201.1 In accordance with TAS 201.1, the standards must be applied to...