and there is no proposed change of use of the area below the elevated PV system components: The area below the elevated PV system components must be accessible consistent with...
Talking Three-Dimensional Models for Way-finding In contrast to raised-line maps, touchable models provide more spatially accurate information, but also have some limitations, and are...
Diagnostic Imaging Equipment: Accessibility Considerations Section 4 introduces the complex considerations raised when considering accessibility standards, such as transfer surface heights...
hereinafter "Releasees"), from and against any and all claims, rights, demands, actions, obligations, liabilities and causes of action of any and every kind, nature and character whatsoever raised...
Floors of amusement rides with wheelchair spaces and floors of load and unload areas shall be coordinated so that, when amusement rides are at rest in the load and unload position, the vertical...
Contrast in percent shall be determined by: Contrast percent = [(B1-B2)/B1] x 100 percent where B1 = light reflectance value (LRV) of the lighter area and B2 = light reflectance...
Executive Order 12866 The Board has determined that this final rule is a significant regulatory action for purposes of Executive Order 12866 since it raises novel legal or policy issues...
In the raised (load) position, the centerline of the seat must be located over the deck, a minimum of 16 inches from the edge of the pool....
Blended transitions are raised pedestrian street crossings, depressed corners, or similar connections between the pedestrian access route at the level of the sidewalk and the level of the...
Carriers must (i) establish a procedure for resolving disability-related complaints raised by passengers with a disability and (ii) designate at least one CRO to be available to handle disability-related...
Recommendation: At narrow routes in particular, consider maintenance of adjacent surfaces as raised or flush or wider route widths in consideration of minimum maneuvering and passage requirements...
Hospital bed control devices, for raising and lowering the bed and for other functions, as well as call buttons, also should be accessible to patients with disabilities....
As a result, grab bars that would permit older adults to raise and lower themselves from the bottom of the tub were not included in bathtub designs....
subjected to discrimination. 2) Suits by the Department of Justice, whenever it has reasonable cause to believe that there is a pattern or practice of discrimination, or discrimination that raises...
The 1991 Standards, at section 4.1.1(1), require all areas of newly constructed facilities to be accessible, but do not contain a specific scoping requirement for lawn seating in assembly...
Section 221.5 provides a new requirement that addresses lawn seating and exterior overflow areas. Such areas are required to be connected by an accessible route....
(d) As used in this section, a “path of travel” includes a continuous, unobstructed way of pedestrian passage by means of which the altered area may be approached, entered, and exited, and...
Modifying vertical rises at door thresholds often requires more than just a ramp, it requires a level-landing, otherwise known as maneuverable clearance area, a firm and stable level surface...
Section 211.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for drinking fountains.
[DSA-AC] The ground level area beneath and immediately adjacent to a play structure or play equipment that is designated by ASTM F 1487 for unrestricted circulation around the play equipment...
Shower stalls that are 60 inches (1525 mm) wide and have no curb may increase the usability of a bathroom because the shower area provides additional maneuvering space. ◼...
It is best to grade the area that is adjacent to the ramp to avoid an abrupt drop-off. If a drop-off exists, then a barrier such as a raised edge or railing must be installed....
The most notable installation concerns were raised at sites where the PIP appeared in good condition, but when tested with the TRIAX did not meet the ASTM standard for impact attenuation...