The height of amusement ride seats designed for transfer shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
Search Results "Recreational Surfacing"
Filters
Commonly Searched Documents
-
11B-1002.5.2 Transfer height
-
Examples of Involvement
Meet with municipal recreation department staff when a new program is being created to ensure the participation of people with disabilities....
-
11B-809.12 Electrical receptacles, controls and switches
When the reach is over a kitchen work surface and base cabinet, the work surface shall be 36 inches (914 mm) maximum above the finish floor and 25 1/2 inches (650 mm) maximum in depth....
-
11B-705.1.1.3 Color and Contrast
Detectable warning surfaces shall contrast visually with adjacent walking surfaces either light-on-dark, or dark-on-light. ...
-
11B-705.1.1.3.2
11B-705.1.1.3.2 Detectable warning surfaces shall provide a 70 percent minimum visual contrast with adjacent walking surfaces....
-
11B-705.1.1.3.2
Detectable warning surfaces shall provide a 70 percent minimum visual contrast with adjacent walking surfaces....
-
Bradley Verge Lavatory Systems
These fixtures are made with Evero® Natural Quartz Surface, the only natural quartz material able to be molded into round and curved shapes....
-
SmartCells Flooring: Softer Anti-Fatigue Mats are NOT Better
Research on anti fatigue matting has shown that an optimized anti fatigue surface requires a number of elements to work together....
-
Elongated surface openings must be perpendicular to the dominant direction of travel, but what if there is no dominant direction of travel?
When there is no dominant direction of cross traffic, openings must be limited to ½” in both dimensions. Where space allows accessible routes to completely bypass the area with...
-
11B-1009.3.1 Sloped entries
Exception: Where sloped entries are provided, the surfaces shall not be required to be slip resistant....
-
R409.4 Height
Top of gripping surfaces of handrails shall be 865 mm (2.8 ft) minimum and 965 mm (3.2 ft) maximum vertically above walking surfaces, ramp surfaces, and stair nosings....
-
Curb or Barrier: ADA Standard Section 405.9.2
Section 405.9.2 covers the current ADA Standards for a curb or barrier that is provided as edge protection at a ramp.
-
ADA25: Bob's Story
After earning a Pre-law degree at the University of Texas at Arlington, Bob earned a Master of Science degree in Recreation Sports Management at the University of Tennessee....
-
General Issues
A new chapter was added through the incorporation of guidelines for recreation facilities and play areas that the Board previously finalized in separate rulemakings....
-
Appalachian Trail Conservancy's "Backcountry Sanitation Manual"
This manual was created in the belief that all remote recreation areas will benefit from an expanded discussion of backcountry sanitation....
-
Adult Tricycles
They can also be used for recreation in a manner similar to bicycles....
-
11B-232.2.1.3 Substitute cells
Has equal physical access as the altered cells to areas used by inmates or detainees for visitation, dining, recreation, educational programs, medical services, work programs, religious...
-
Manual vs. Power (RMS Values)
Power wheelchair The last section demonstrated that the vibration data for the engineered surfaces are much more consistent than the outside surfaces....
-
Appendix C: Resources
It promotes access and inclusion for people with disabilities to parks, recreation, and tourism. The center promotes personal wellness and community health....
-
Seat Height: ADA Standard Section 1009.2.4
The height of the lift seat shall be designed to allow a stop at 16 inches (405 mm) minimum to 19 inches (485 mm) maximum measured from the deck to the top of the seat surface when in the...
-
11B-246.7 Trails and paths
Buildings and other functional areas shall be served by paths or walks with firm and stable surfaces....
-
11B-405.9.1 Reserved
[2010 ADAS] 405.9.1 Extended Floor or Ground Surface....
-
Amusement Ride Seats Designed for Transfer: ADA Standard Section 1002.5
Where possible, designers are encouraged to locate the ride seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
Grab Bars: ADA Standard Section 1009.5.7
Where a grab bar is provided on each step, the tops of gripping surfaces shall be 4 inches (100 mm) minimum and 6 inches (150 mm) maximum above each step and transfer platform....
