Copies of the referenced standard may be obtained from the Human Factors and Ergonomics Society, P.O....
Search Results "Industry Standard"
Filters
Commonly Searched Documents
-
702.4 Human Factors and Ergonomics Society (HFES)
-
702.5 Institute of Electrical and Electronics Engineers (IEEE)
Copies of the referenced standard may be obtained from the Institute of Electrical and Electronics Engineers, 10662 Los Vaqueros Circle, P.O....
-
§ 35.151(g) Assembly areas
Assembly areas subject to the proposed standards shall comply with the provisions applicable to assembly areas, including, but not limited to, sections 221 and 804. ...
-
e-iv
[ADA Standards § 4.10.12 (3)] Yes No...
-
d-vi
[ADA Standards § 4.8.4] Yes No...
-
M6
[ADA Standards §§ 4.22.3; 4.2.3] Yes No...
-
K6
[ADA Standards § 5.5] Yes No...
-
E103.2 Undefined Terms (Section-by-Section Analysis)
E103.2 Undefined Terms (Section-by-Section Analysis) This section proposes that the meaning of terms not defined in section E103.4 or in referenced standards shall be given their ordinarily...
-
Question 9
Is there a need for separate standards for bariatric medical equipment and furniture in the Department's equipment and furniture regulation?...
-
Raised Crossings
Consult local Standards for application requirements, including slope for vehicle traffic, height, and markings....
-
11B-805 Medical care and long-term care facilities
ETA Editor's Note The numbering of subsections within Section 11B-805 is not aligned between CBC and 2010 ADA Standards....
-
E202.6.1 Required Documentation (Section-by-Section Analysis)
Documentation (Section-by-Section Analysis) This section proposes to require that agencies document in writing the basis for determining that ICT fully conforming to applicable 508 Standards...
-
Sections 4.8.5 and 4.9.4
• Sections 4.8.5 and 4.9.4 of the 1991 Standards require handrail gripping surfaces to be continuous, and to be uninterrupted by newel posts, other construction elements, or obstructions...
-
QUALIFIED INTERPRETERS
An individual does not have to be certified in order to meet this standard....
-
101.1 General
These standards are intended to be consistent to those contained in the 2010 Standards for Accessible Design, and are generally the same except as noted in italics....
-
R105 Definitions (Section-by-Section Analysis)
Collegiate dictionaries are used to determine the meaning of terms that are not defined in the proposed guidelines, referenced MUTCD standards, or regulations issued by federal agencies...
-
Q5: Should a school district revise its policies and procedures regarding the determination of coverage and provision of services under Section 504 and Title II?
A: Yes, if those policies and procedures do not implement the Amendments Act's new legal standards....
-
A.2.ii. - Should EIT be compatible with assistive technology?
In some cases, the standards require that the acquired EIT be readily usable without the need for assistive devices....
-
Are self-evaluations and transition plans required to be updated?
Although there is no requirement to update them, updating is the best means to ensure compliance with current regulations and design standards. A lot has changed in 27 years....
-
A. Accessibility Laws
. §§ 12101, et seq. and all of its implementing regulations and design standards; the Rehabilitation Act of 1973, 29 U.S.C. §§ 790, et seq. and all of its implementing regulations and design...
-
The National Highway Traffic Safety Administration’s (NHTSA) motor vehicle safety regulations require that a wheelchair lift be tested to withstand a 600-pound load. If the manufacturer states that the design load is 800 pounds, can the transportation operator limit actual use to 600 pounds for safety reasons?
The NHTSA safety standards and the DOT ADA regulations were designed to complement each other....
-
407.7 Color (Section-by-Section Analysis)
The proposed section is the same as existing 508 Standards § 1195.25(g), and is consistent with 255 Guidelines § 1193.41(c)....
-
E102.5 Internet Engineering Task Force (IETF)
Copies of the referenced standard may be obtained from the Internet Engineering Task Force (http://www.ietf.org/)....
-
4.10.12(2)
All control buttons shall be designated by Braille and by raised standard alphabet characters for letters, arabic [sic] characters for numerals, or standard symbols as shown in Fig. 23(a...