Glynn-Johnson has been providing the highest quality door control hardware for 75 years. Glynn-Johnson uses only state-of-the-art technology and manufacturing processes....
Search Results "Door Height"
- Allegion Glynn-Johnson Push/Pull Latches
- Cal-Royal Legacy Series Locksets
- TownSteel CDC-110 Classroom Instruder Mechanical Cylindrical
-
11B-707.7.2 Characters
Characters displayed on the screen shall be in a sans serif font. Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I". Characters shall contrast...
-
M301.4.1 Clearance in Base
The base of diagnostic equipment shall provide a clearance 39 inches (990 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep...
-
T702 Signs
[See subsections ...]
-
4.1.3(16)(a)
(a) Signs which designate permanent rooms and spaces shall comply with 4.30.1, 4.30.4, 4.30.5 and 4.30.6.
-
Figure M2: M301.4 Lift Compatibility
(at Diagnostic Equipment for Use by a Patient in a Supine, Prone, or Side-Lying Position)
-
M301.4.1 Clearance in Base
The base of the equipment shall provide a clearance 44 inches (1120 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum...
-
Handrails [§504.6, §505]
Handrails [§504.6, §505] Handrails are required on both sides of stairs and must be continuous within the full length of each stair flight. Inside handrails on switchback or...
-
11B-707.7.2 Characters
11B-707.7.2 Characters. Characters displayed on the screen shall be in a sans serif font. Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I"....
-
11B-707.7.2 Characters
Characters displayed on the screen shall be in a sans serif font. Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I". Characters shall contrast...
- Figure 404.2.4.1(c) Maneuvering Clearances at Manual Swinging Doors and Gates: Front Approach, Push Side with Closer and Latch – Drawing from the U.S. Access Board
- Stanley QME 100 Series Grade 1 Heavy Duty Mortise Locks
- Stanley QMS 100 Series Grade 1 Heavy-Duty Mortise Locks
- Allegion Falcon 1490 Series Exit Devices
- Allegion Falcon 1790 Series Exit Devices
- TownSteel CSRC Series, Grade 2, Clutched, Conical Rose Cylindrical Locks
- TownSteel CB Series, Grade 2 Non-Clutched Flat Rose Cylindrical Locks
-
1009.4.2 Height
1009.4.2 Height. The height of the transfer wall shall be 16 inches (405 mm) minimum and 19 inches (485 mm) maximum measured from the deck. Figure 1009.4.2 Transfer Wall Height...
- Brewer Access™ High-Low Exam Table
- Allegion Falcon 1690 Series Exit Devices
- Yale Affinity® Smart Card Locks