Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
Search Results "Side Entry"
Commonly Searched Documents
-
404.2.10 Door and Gate Surfaces
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
5.8.1 Wheelchair Spaces on Raised Platforms Recommendations
Where wheelchair spaces can be entered only from the side, the wheelchair space shall be 60 inches deep minimum....
-
Utility and Sewage Hookups [1011.2, 1011.3, and 1011.6]
Internet connections, in camping units with mobility features and at sewage hookups in dump stations, a minimum of 30 by 60 inches of clear ground space must be provided with the long side...
-
711.3.2 Membrane penetrations
Outlet boxes on opposite sides of the wall shall be separated as follows: 1.1. By a horizontal distance of not less than 24 inches (610 mm); 1.2....
-
Requirement 5. Light switches, electrical outlets, thermostats and other environmental controls in accessible locations.
the reach is over an obstruction (for example, an overhanging shelf) between 20 and 25 inches in depth, the maximum height is reduced to 44 inches for forward approach; or 46 inches for side...
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height. 3. ...
-
11B-505.6 Gripping surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
501.1 Scope
Applications may be web-based or client-side software....
-
Common Requirements (R304.5) (Section-by-Section Analysis)
Common Requirements (R304.5) (Section-by-Section Analysis) The clear width of curb ramp runs (excluding flared sides), blended transitions, and turning spaces must be 1.2 meters (4 feet...
-
FAQ: Why should I enter ADA references in the content I add to my Corada WorkSpace?
When the reference options are displayed, click on "308.3 Side Reach." Repeat this process until all applicable/desired references are entered. ...
-
2.7 Comparing Visual Detection Rates and High Conspicuity Ratings for Detectable Warnings
Note that when detectable warning color was similar to the side walk color, the number of people who would be served by the visual properties of the detectable warning decreased markedly...
-
Accessible Pathway & Corridor: Minimum Clear Width Required for 90-degree Turn
The other side of each leg had moveable walls. The enclosed space was incrementally increased until a user could pass through the turn successfully....
-
1.1.14 Flatness of ramp cross slope
As the ramp gets wider, users may tend to travel toward one side or the other, especially if the ramp is not a curb ramp and has handrails....
-
Hours and Days of Service
For example, if a provider uses its own paratransit vans during high demand periods, it could use a private contractor or user-side subsidy provider during low demand periods....
- Delta High Rise Faucet with Proximity™ Sensing Technology Battery Operated 590TP1120
- Corbin Russwin Inc. ED4000 Series Narrow Stile Exit Device
- FBD Partnership Four Flavors Frozen Beverage Dispenser
- Grohe Veris Three-Hole Basin Mixer 1/2" M-Size
- Pilot Rock FSW-30 Campfire Ring
- Kawneer North America Flushline™ Entrances
- Assisted Living Directory - Top Assisted Living Markets - Albuquerque, New Mexico Assisted Living Facilities & Senior Care