The surface of the transfer system shall not be sharp and shall have rounded edges....
Search Results "Ramp Surface"
-
11B-1009.5.5 Surface
-
M301.2.3 Size
The size of the transfer surface shall comply with M301.2.3.1 or M301.2.3.2. The size of transfer surfaces shall be measured from center points of their opposing sides....
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
4.7.9.1 General
Where utility sinks are provided in a recreation facility that also contains a cook top or conventional range, at least 5 percent, but not less than one in each accessible space,...
-
M301.3.1 Transfer Supports
A.1) A transfer support will extend horizontally along the side of the patient scanning/imaging table at least the minimum width of the transfer surface, but in all cases a 28 inches minimum...
-
11B-406.2.2 Sides of curb ramps
Where provided, curb ramp flares shall not be steeper than 1:10....
-
11B-406.2.2 Sides of curb ramps
Where provided, curb ramp flares shall not be steeper than 1:10....
-
4.1.3(5)*
EXCEPTION 3: Accessible ramps complying with 4.8 may be used in lieu of an elevator....
-
CHAPTER 4: BOARDING AND ALIGHTING
[See subsections ...]
-
Adjustable Height Range Considered
to make up the difference between the two surfaces, in one direction or the other....
-
GameTime Apollo Playground Equipment Plan
Requires the Premium User plan or above. (Login or upgrade your account!) -
Curb or Barrier: ADA Standard Section 405.9.2
Section 405.9.2 covers the current ADA Standards for a curb or barrier that is provided as edge protection at a ramp.
-
2.8 Aircraft and Air Carrier Facility Accessibility.
Lifts, ramps, or other suitable devices not normally used for the movement of freight must be available, if the terminals at such airports are not equipped with passenger loading bridges...
-
Program Accessibility
accessibility,” includes a requirement to evaluate existing facilities in the public right-of-way for barriers to accessibility, including identifying non-existent or non-compliant curb ramps...
-
5.3.2 Transfer Sides Recommendations for M301
the long side of the surface....
-
Attachment I
of the ramp parallel with the ground surface. ...
-
5.4.2.1 Transfer Support Length for Stretchers
5.4.2.1 Transfer Support Length for Stretchers. Transfer supports on stretchers should be a minimum of 15 inches long.
-
Accessible Parking Space
Accessible Parking Space
-
11B-250.1 General
Exceptions: Curb ramps and blended transitions with detectable warnings complying with Section 11B-247 may be used to connect raised circulation paths and pedestrian crossings within...
-
11B-250.1 General
Exceptions: Curb ramps and blended transitions with detectable warnings complying with Section 11B-247 may be used to connect raised circulation paths and pedestrian crossings within...
-
Sloped Surfaces
Measuring the slope of a ramp, parking space, pedestrian route, or other ground or floor surface is important to identify whether the surface is accessible....
-
Why are surface characteristics specified?
Transportation Institute at The Pennsylvania State University compared the slip-resistance needs of persons with mobility impairments and those without disabilities walking on level and ramped...
-
M301.3.1 Transfer Supports (Section-by-Section Analysis)
The only change in the final rule was to update the cross reference to applicable transfer surfaces to accommodate the changes made to transfer surfaces, described above in Section IV.B.1...
