Where a wheelchair space can be entered only from the side, the wheelchair space shall be 60 inches (1524 mm) deep minimum. Advisory 11B-802.1.3 Depth....
Search Results "Latch Side Clearance"
-
11B-802.1.3 Depth
-
11B-604.6 Flush controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with Section 11B-604.8.2....
-
Salsbury Industries Recessed Mounted Cell Phone Storage Locker 7 Door High Unit Master Keyed Locks
than the unit's width, 2 1/4" less than the unit's height and equal to the unit's depth Fits into a rough opening and secured with mounting hardware (not included) through the back or side...
-
Salsbury Industries Recessed Mounted Cell Phone Storage Locker 5 Door High Unit
than the unit's width, 2 1/4" less than the unit's height and equal to the unit's depth Fits into a rough opening and secured with mounting hardware (not included) through the back or side...
-
Salsbury Industries Recessed Mounted Cell Phone Storage Locker 7 Door High Unit Resettable Combination Locks
than the unit's width, 2 1/4" less than the unit's height and equal to the unit's depth Fits into a rough opening and secured with mounting hardware (not included) through the back or side...
-
Salsbury Industries Recessed Mounted Cell Phone Storage Locker 7 Door High Unit
than the unit's width, 2 1/4" less than the unit's height and equal to the unit's depth Fits into a rough opening and secured with mounting hardware (not included) through the back or side...
-
4.2.5* Forward Reach
If the high forward reach is over an obstruction, reach and clearances shall be as shown in Fig. 5(b)....
-
4.34.5.3 LAVATORY, MIRRORS, AND MEDICINE CABINETS
(2) If a cabinet is provided under the lavatory in adaptable bathrooms, then it shall be removable to provide the clearances specified in 4.22.6....
-
Don-Jo Mfg., Inc. Pull Plate 7011
Number 7011 Dimensions 3-1/2" x 15" Ansi J405 Ctc 5-1/2" Diameter 5/8" Projection 2" Clearance...
-
Bobrick MatrixSeries Seat-Cover Dispenser B-5221
Allow 5" (125mm) minimum clearance from bottom of dispenser to top of any horizontal projection for filling dispenser from below unit....
-
1134A.7 Water closets
Water closets shall be located within bathrooms in a manner that permits a grab bar to be installed on at least one side of the fixture....
-
ASI Storage Solutions Traditional Plus Locker
collection features 14 gauge doors with 16 gauge full-height reinforcement channels, frame-secured 11 gauge frame hooks with protruding padlock hasps, and a maintenance-free, single-point latching...
-
A) Accessible Parking
Van-Accessible Parking Spaces One of every eight accessible parking spaces, but always at least one, must be accessible for vans with a side-mounted lift....
-
Thresholds at Doorways
The 1991 Standards and the 2010 Standards require raised thresholds that exceed ¼ inch in height to be beveled on each side with a slope not steeper than 1:2....
-
410.6 Doors and Gates
Side doors and gates shall provide a clear width 42 inches (1065 mm) minimum....
-
Openings, Width and Length of Wheelchair Space
Wheelchair access can be provided onto the ride vehicle in many ways, including, but not limited to, rear entry, side entry, or side entry with a turntable....
-
Rotational Penetrometer
The test for stability requires the caster of the Rotational Penetrometer to be moved from side to side to determine the horizontal displacement of the surface material....
-
1. Accessible toilet
Accessible toilet with rear and side grab bars, clear floor space for wheelchair transfer, and an accessible flush valve....
-
804.6.5.2 Bottom-Hinged Door Ovens
Bottom-hinged door ovens shall have the work surface required by 804.3 positioned adjacent to one side of the door....
-
5.2.3 Transfer Surface Measurement
The transfer surface should be measured from the center-point of each side of the transfer surface....
-
A7
Is the width of the curb ramp surface at least 36 inches (not counting the side flares)? [ADA Standards § 4.7.3] Yes No...
-
B7-a
Is the curb ramp surface at least 36 inches wide, excluding flared sides? [ADA Standards § 4.7.3] Yes No...
-
§ 38.73(a)(1)
(1) All passenger doorways on vehicle sides shall have minimum clear openings of 32 inches when open....
-
§ 38.53(a)(1)
(1) Passenger doorways on vehicle sides shall have clear openings at least 32 inches wide when open....
